Push or pull the plunger to hold your workpiece from the side.

Pull the handle backward to push the plunger forward. These clamps secure when the plunger is fully extended to hold your workpiece from the side.

Secure your workpiece from the side by fully extending the plunger, and push a lever to lock the handle in place.

Moving parts are protected by a metal cover when the clamp is engaged to prevent dirt and dust from clogging the clamp.

The handle can be rotated 125° for easier access or extra clearance above the clamp.

The plunger can be locked at any position along its travel.

Also known as press screws, mount these clamps through a drilled hole and turn the crank to move the jaw end of the screw in and out.

Combine fast-threading components to build a clamping assembly.

Mount these clamps to a bench top or other surface to keep workpieces in place.

Hold workpieces of slightly different thicknesses with one clamp. These clamps automatically adjust to compensate for imperfections or small inconsistencies on the material’s surface.

Push the lever to lock the handle and prevent accidental opening.

Reduce the chance of getting pinched when unclamping. These clamps have more space between the handle and the arm than other low-profile toggle clamps.

Hold workpieces of different thicknesses without adjustment.

Often used when assembling small parts, these small clamps have the holding strength of a full-size clamp.

Two sets of mounting holes allow mounting on the bottom or side.

The mounting base secures these clamps to a rail or bar.

These clamps have mounting holes on the bottom.

Suitable for production applications, these clamps have double the service life of other air-powered toggle clamps.

Mount to the top of your workbench.

A highly durable construction with hardened steel pivot pins and bushings provides a long service life.

Fit the draw arm over a latch plate and pull the handle to clamp.

Mount the clamp on a lid and the latch plate on the side of a container.

Hold the workpiece down against a bench or table.

Screw these clamps directly into a tapped hole in a fixture.