Push the lever to lock the handle and prevent accidental opening.

Mount the clamp on a lid and the latch plate on the side of a container.

Smaller than standard push/pull toggle clamps, these are often used for electronics and small fixturing applications.

Pull the handle backward to push the plunger forward. These clamps secure when the plunger is fully extended to hold your workpiece from the side.

Secure your workpiece from the side by fully extending the plunger, and push a lever to lock the handle in place.

Hold workpieces of different thicknesses without adjustment.

Panel mount through a hole with the included nut, or drill and tap a hole to flush mount. A pushing or pulling motion holds workpieces from the side.

Secure these clamps to a rail or bar.

Drill a hole to mount these clamps through a surface and secure the mounting flange with screws. The plunger can be locked at any position along its travel.

To prevent accidental opening, these latches have a safety catch.

These latches use downward compression to pull surfaces together for sealing gasketed doors.

A plastic-coated handle and hook prevents the release of particles from metal-to-metal contact, which makes these latches good for clean room applications.

These latches are typically used to secure hoods and covers.

To prevent accidental opening, these latches have a safety catch.

The latch arm is coated with vinyl so it won't scratch surfaces.

No need for a strike plate, these latches hook into a lip or notch.

These latches have a safety catch to prevent accidental opening.

To prevent accidental opening, these latches have a safety catch.

Use these L-handle latches to draw lightweight surfaces together.

Lift and turn the handle 180° to open and close these latches.

To secure overlapping components, pull the slide over the stud until they snap together. These latches resist shock and vibration.

Add a padlock to secure these latches, which reach around corners to pull two surfaces together.

Mount these latches on a corner to draw perpendicular surfaces together. They have a safety catch to prevent accidental opening.

An integrated slide bolt extends into the strike plate to resist pull and vibration from side-to-side, front-to-back, and up-and-down forces.

Lift and turn the handle 180° to open and close these latches. Add a padlock to secure.