These rings mount flush and fold down when not in use to eliminate obstructions.

Dimples hold the base tight to prevent it from swiveling.

Also known as pad eyes, these rigid rings provide a strong, fixed anchor point.

Accommodate ties in any direction with these rings that swivel all the way around and pivot 180°.

Use these rings to make a temporary anchor point on ferrous metal surfaces.

Clamp around a pipe or tube to guide rope.

These rings pivot to secure loads in various directions.

The flat side allows you to connect webbing and strapping, so they lay flat and resist bunching.

Smaller than lifting oblong links, these links provide room for snaps, carabiners, and other non-lifting connectors.

The narrow end restricts the movement of rope and chain, and the wide end allows room to attach multiple connectors.

Use for three-sided connections. Flat sides ensure webbing and strapping lay flat, so they won't slide and bunch.

The twisted shape of these links prevents loads from rotating or knotting.

Drive the end through the eye using a ball peen hammer and then weld or flatten the extended end to close. These links are also known as cold shuts.

Restrict rope and chain movement with the narrow end, attach multiple connectors to the wide end, and then hammer these links closed.

Also known as C-links, the notch in these links lets you slip additional links on or remove links quickly.

Use these links for general lifting applications.

Providing better load distribution and alignment than single oblong links, these reduce wear in three and four leg slings.

Hammer the pin through the center to assemble these links. They’re also known as hammer locks and sling links.

The flat side lets webbing and strapping lay flat, so they don’t slide and bunch.

Choose these hoist rings when you need to lift your load from the side.

Designed for angular lifting, hoist rings resist stresses that would bend or break an eyebolt. They have a lifting ring that pivots 180° front to back to compensate for roll and sway when lifting heavy or unbalanced loads.

An indicator dot changes from red to black when these hoist rings are properly tightened, eliminating the need for a torque wrench.

The ball bearing on these hoist rings makes it easy to rotate your load even after it’s suspended.

With three different thread sizes, these hoist rings are useful when you need to lift different types of equipment.

Fasten these handles directly to the front of your surface to open and close a variety of doors and drawers on chests, crates, furniture, machines, and equipment. When not in use, the grip folds out of the way.

Anchor these ringbolts where you need them, then remove the ring when not in use. Once installed, the mounting bolt stays in place. Insert the ring by threading into the mounting bolt; remove by unthreading it.