Made from stainless steel or plated with nickel, these bushings resist corrosion. A mounting flange prevents movement during tightening. As screw-clamp bushings, they're good for shock loads. When you tighten the clamping screws, the bushing's inner sleeve tightens onto the shaft and the outer sleeve expands to hold your sprocket, pulley, or gear.

Insert these nickel-plated steel bushings into the bore of your sprocket for flush or recessed mounting in wet environments. When you tighten the included clamping screws on these bushings, their inner sleeve contracts onto the shaft and their outer sleeve expands to hold your sprocket, pulley, or gear. This keeps bushings from slipping during sudden starts and stops.

The tapered barrel on these bushings is split on both sides, allowing them to contract more tightly around the shaft than quick-disconnect and taper-lock bushings. They're for use with split-tapered sprockets and pulleys of the same bushing trade number. As you tighten the included screws, the bushing grips the shaft and pulls it into the sprocket or pulley.

Tighten just one set screw to clamp these bushings evenly around your shaft. The screw forces hydraulic fluid in between the double-walled sleeve, expanding the two walls against the shaft and the hub of your sprocket, pulley, or gear for a tight hold. Since you don’t have to tighten multiple screw clamps individually, these bushings are quick to adjust and more likely to stay aligned on your shaft. They’re also good for shock loads. A mounting flange prevents movement during tightening. Use a hex key to tighten.

Note: To avoid deforming the sleeve walls, make sure to fully tighten the screw.