Insert these nickel-plated steel bushings into the bore of your sprocket for flush or recessed mounting in wet environments. When you tighten the included clamping screws on these bushings, their inner sleeve contracts onto the shaft and their outer sleeve expands to hold your sprocket, pulley, or gear. This keeps bushings from slipping during sudden starts and stops.

For technical drawings and 3-D models, click on a part number.

Tighten just one set screw to clamp these bushings evenly around your shaft. The screw forces hydraulic fluid in between the double-walled sleeve, expanding the two walls against the shaft and the hub of your sprocket, pulley, or gear for a tight hold. Since you don’t have to tighten multiple screw clamps individually, these bushings are quick to adjust and more likely to stay aligned on your shaft. They’re also good for shock loads. A mounting flange prevents movement during tightening. Use a hex key to tighten.

Note: To avoid deforming the sleeve walls, make sure to fully tighten the screw.

Stainless steel bushings have excellent corrosion resistance in most environments.

For technical drawings and 3-D models, click on a part number.

The screw connections on these bushings easily mate to compatible quick-disconnect sprockets and pulleys. Bushings fit quick-disconnect (QD) sprockets and pulleys of the same bushing style. As you tighten the included screws, the bushing grips the shaft and pulls it into the sprocket or pulley.

For technical drawings and 3-D models, click on a part number.