A quick push is all it takes to actuate these switches.

The built-in contact block in these switches extends behind the panel half the depth of most other 22 mm switches, saving valuable space.

Mount these switches in panel cutouts where changing a battery or routing wires might be difficult—they power themselves when you push the button.

A base that lights up draws attention to emergency stops. When pushed, these switches immediately cut power.

Actuate these switches with the push of a button. Their buttons are distinct colors to help you quickly spot switches without labels.

The face of these switches mounts flush against a panel, so they're easy to clean and hard to damage.

Change the cover on these switches without replacing them entirely—they come with seven snap-on covers in different colors. The colors help you quickly identify switches without labels.

Use these switches where ignitable gas and dust may be present. Their contact blocks are UL listed for Class I, Division 2, Groups B, C, and D hazardous locations.

Rated NEC Classes I, II, and III, these switches have a housing that keeps fire and sparks in, so they won’t ignite gases, vapors, or dust. To save space on your panel, they can control multiple circuits.

Install in 8 mm dia. cutouts.

Install in 14 mm dia. cutouts.

Sized for 4 mm or 6 mm panel cutouts, these switches are often used with circuit boards to control electronics.

Operate low-voltage devices that require less than 48 volts, such as doorbells and buzzers.

Immediately cut power with a single push.

Operate low-voltage devices that require less than 48 volts, such as doorbells and buzzers.

Send a signal from your circuit board with the push of a button.

These familiar push-button switches mount to flat surfaces.

A protective plastic enclosure resists dents, chips, and cracks, so you can install these switches outside of panels.

With a stainless steel enclosure, these switches are more durable than aluminum and plastic. They're rated NEMA 4X for protection from corrosion and washdowns.

Use these switches where ignitable gas and dust may be present. They're rated for use in hazardous locations.

These aluminum switches are rated NEMA 4, NEMA 13, and IP66 for protection from washdowns and oil/coolant spraying.

Immediately cut power with a single push.

Snap these switches onto your T-slotted framing rails—no need to drill or disassemble your existing structure.

Mount these switches in an outlet box. Also known as palm-button switches, they have a large button that makes them easy to use even while wearing gloves.

Choose an actuator and contact block to make your own 22 mm plastic switch.

Choose an actuator and contact block to make your own 16 mm switch.

Operate equipment from up to 330 feet away—these switches include a transmitter and a receiver that connects to equipment.

Control machinery such as cranes, hoists, or trolleys with a wireless switch. About the size of a cell phone, these switches fit in the palm of your hand.

Control cranes and other mobile machinery in dirty, outdoor, and wet environments without damaging your switch.

A durable rubber housing covers the buttons and protects these switches from impact.

Also known as deadman switches, these switches make sure equipment only runs if you lightly press the hand grip. If you let go or a shock tightens your grip, they cut power.