Protect switches from moisture and dust by replacing panel mounting nuts with these rubber covers.

Made of stainless steel, these covers offer more protection than rubber covers. Use them in place of panel mounting nuts to protect push-button switches from impact, moisture, and dust.

To prevent accidents, these switches won’t let your machine start running unless two people in different locations coordinate control. This is useful for large operations where it would be difficult to hear or see someone call for power to be cut. They come with two foot switches that communicate wirelessly—both need to be pressed at the same time for your machine to run. For example, if used with a machine that pulls wire up a building through conduit, this means that two people dozens of floors apart can each stop the machine by releasing their foot. As an extra precaution, give the included pendant switches to people walking around your operation. If they see a problem, the pendant switches shut power off with a push of a button, even if the foot switches are pressed.

The foot switches work up to 3.7 miles away from each other if there’s a clear line of sight between the two. If there are walls or other obstacles, they work up to 1,500 ft. away from each other. Plug your equipment into the receiver foot switch before plugging the switch into an outlet—no wiring is required.

It takes two hands to activate these switches, minimizing the risk of accidental equipment start-up. They have an emergency stop push-button to immediately cut power. They’re rated IP65 for protection from low-pressure washdowns.

Switches turn circuits on and off with a light touch, even when wearing gloves. An infrared sensor detects the lightest finger contact, and an indicator lights up to confirm when they are activated. Because they don't require you to press down a button to operate, they meet ANSI B11.TR1 standards to reduce hand, wrist, and arm fatigue. You'll need a relay or controller to complete your system—upgrade to a controller if you plan to operate additional devices beyond your switch.

It takes two hands to activate these switches, minimizing the risk of accidental equipment start-up. They have an emergency stop push-button to immediately cut power. They’re rated IP65 for protection from low-pressure washdowns.

Switches with push-button actuators require a safety relay (sold separately) for a complete system.