Because these switches mount flush against a panel, they're easy to clean and hard to damage.

More durable than standard metal switches, these can handle tough, repetitive use.

Able to handle tough, repetitive use, these switches are more durable than standard plastic switches.

Use these switches where ignitable gas and dust may be present. Their contact blocks are UL listed for Class I, Division 2, Groups B, C, and D hazardous locations.

Use these switches where ignitable gas and dust may be present. Their contact blocks are UL listed for Class I, Division 2, Groups B, C, and D hazardous locations.

Install in 16 mm dia. cutouts.

Operate low-voltage devices that require less than 48 volts, such as doorbells and buzzers.

Sized for 4 mm or 6 mm panel cutouts, these switches are often used with circuit boards to control electronics.

Because these switches mount flush against a panel, they're easy to clean and hard to damage.

Install in 14 mm dia. cutouts.

Rated NEMA 4X and 13, all switches resist corrosion and can withstand washdowns and oil/coolant spraying.

With a stainless steel enclosure, these switches are more durable than aluminum and plastic. They're rated NEMA 4X for protection from corrosion and washdowns.

Rated NEMA 3S, NEMA 4X, NEMA 13, and IP66, these plastic switches resist corrosion better than aluminum switches and withstand washdowns and oil/coolant spraying.

Often used to trigger alarms, these switches have a recessed button to prevent accidental activation. Mount under desks or in other discrete locations to avoid drawing attention.

Immediately cut power with a single push.

Choose an actuator and contact block to make your own 30 mm switch.

Choose an actuator and contact block to make your own 22 mm plastic switch.

Use these hand-held switches with mobile machinery.

Control cranes and other mobile machinery in dirty, outdoor, and wet environments without damaging your switch.

Operate equipment from up to 330 feet away—these switches include a transmitter and a receiver that connects to equipment.

The light touch of a finger turns circuits on and off without pressing down a contact.