We will reply to your message within an hour.
More
A ratchet mechanism allows you to turn fasteners without removing and repositioning the wrench.
The handle is covered in rubber for a comfortable grip.
No need to pull the socket off the tool—push a button to release.
When the ratchet head becomes worn or damaged, change it out for a new one.
A gasket seals in permanent lubrication and keeps out dirt, dust, and moisture.
Twist the grip to rapidly turn a socket before final tightening or to remove a fastener once loosened. The handle also swings like a traditional ratchet wrench.
Also known as a construction or spud handle, wrenches use the pointed end to align bolt holes.
The shaft on these wrenches extends and locks.
Made of aluminum-bronze, these wrenches satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present.
Insulated to protect against accidental contact with live electrical circuits, these wrenches are tested to 1,000 volts to meet IEC 60900.
Pivot the head to access fasteners in tight spots.
The 20° offset head provides clearance when reaching over obstructions.
Rather than teeth, these wrenches use a series of rollers to engage the ratchet, enabling work in the tightest of spaces. Also known as silent ratchets, they don't make the traditional click sound when turned.
Turn sockets in the most confined spaces.
Set the desired torque and the wrench indicates when it's reached with an audible click and an impulse in the grip.
Unlike most torque wrenches, you don’t have to return the torque setting to the lowest value after use. These tools are also known as split-beam torque wrenches.
Made of beryllium copper, these wrenches satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present.
When the set torque is reached, these wrenches signal with an audible click and an impulse in the grip.
These wrenches slip to disengage and stop turning the fastener when the set torque is reached, preventing overtightening.
Turn sockets from above when there's not room to swing a standard wrench handle.
Trust the precision of your measurements—these wrenches are accurate to ±2%.
Measure with an accuracy of ±7%.
These wrenches have an accuracy of ±2.0%.
Trust the precision of your measurements—these wrenches are accurate to ±1%.
Measure with an accuracy of ±2%.
The most advanced torque wrenches we offer, these tools store and recall up to 1,500 torque and angle measurements.
A main pointer on the dial shows torque as it’s being applied and a memory pointer indicates the maximum torque reached.
Set torque and the wrench will prevent you from exceeding it. These are also known as nutrunners.
A ratchet mechanism allows you to turn fasteners in tight spaces without removing and repositioning the wrench.
Ratchet mechanisms allow you to turn fasteners in tight spaces without removing and repositioning the tool.
An insulated handle protects against accidental contact with live electrical circuits. These wrenches are tested to 1,000 volts to meet IEC 60900.
An extra-long handle provides access to hard-to-reach fasteners and increases leverage.
The 25° offset heads give you additional clearance to turn hard-to-reach fasteners.
The offset head gives you additional clearance to turn hard-to-reach fasteners.
Open the jaws to fit around a fastener like an open-end wrench; close the jaws and the wrench acts like a ratcheting box wrench.
The heads are offset to provide clearance for reaching over obstructions.
Change heads to use these tools as an open-end, box, square drive, or hex-key wrench.
Pivot the box end for access to fasteners in tight spots.