Their small size makes these miniature fittings a good choice for cramped, confined spaces.

When you’re short on vertical space, these manifolds are a good fit—they have outlets on the side instead of on top, so they have a lower profile than rectangular manifolds. Use them to distribute air or fluid to five locations from a single supply source.

Change inch threads to metric with these adapters, or swap metric threads for inch. An external hex lets you tighten or loosen them with a wrench.

One side inch, one side metric, and a hex in the middle—these handy fasteners connect two female-threaded parts, such as coupling nuts, adapting from inch threads to metric. Tighten with a standard wrench.

Adapt threaded rods from inch to metric. These adapters connect two male-threaded fasteners, so you can change the gender of a mating part or increase or decrease its thread size. The hex-shaped body fits into the head of a standard wrench.

A black-phosphate finish provides mild corrosion resistance.

These assortments include various sizes of thread-locking inserts.

A black-phosphate finish provides mild corrosion resistance.

Forming the strongest hold of any of our threaded inserts, these inserts have a distorted internal thread to lock screws into place and keys that drive into surrounding material to prevent slipping and rotating.

Made of Nitronic 60 stainless steel, these inserts prevent the screw from binding or sticking without any coating or lubricant that could contaminate particle-free environments.

A dry film keeps the screw from sticking or binding in these inserts during installation.

A distorted thread grips the screw to resist loosening.

Without a prong to break off and retrieve, these inserts are often used where debris could cause damage.

Inserts come with a through-hole tap and installation tool.

These 18-8 stainless steel inserts have better corrosion resistance than brass inserts and may be mildly magnetic.

These 18-8 stainless steel inserts have better corrosion resistance than brass inserts and may be mildly magnetic.

These aluminum inserts are 70% lighter than brass inserts, electrically conductive, and nonmagnetic. They have good corrosion resistance, which is comparable to brass but not as good as stainless steel.

70% lighter than stainless steel, these aluminum inserts are mildly corrosion resistant and nonmagnetic.

The barbed sides keep these securely in place even before a screw is installed.

Assortments include various sizes of inserts, a soldering iron, a ceramic insulation tube, and installation tips.

Also known as Trisert inserts, these cut threads into plastic and have better holding power than press-fit inserts.

The most corrosion resistant tee nut inserts we offer, these inserts stand up to chemicals and salt water.

The flange keeps these inserts from being pulled through a hole and provides a load bearing surface.

Made from brass, these inserts are nonmagnetic, mildly corrosion resistant, and electrically conductive.

Press these inserts into a drilled hole and the flexible metal teeth anchor them in the material. Use them with carbon fiber, fiberglass, and garolite.

The most corrosion resistant twist-resistant rivet nuts we offer, these stand up to chemicals.

A hex-shaped body provides the highest twist resistance of any rivet nut.

About twice as strong as aluminum rivet nuts, these low-profile rivet nuts have a cadmium or tin-zinc plating for corrosion resistance.

The most corrosion resistant low-profile rivet nuts we offer, these stand up to chemicals.

A PVC foam seal under the flange keeps liquids and gasses from leaking between the nut and the surrounding material.

The thread area is enclosed, which prevents leakage past the threads from either side of your application.