A lever reverses the ratchet direction.

A lever reverses the ratchet direction.

Pivot the box end for access to fasteners in tight spots.

Made in the U.S.A., these tools handle the toughest industrial applications, provide the best grip on fasteners, and have a superior finish.

Flip these wrenches over to ratchet in the opposite direction.

A spline-shaped box end turns spline, hex, and 12-point fasteners. This shape also gets a better grip on rounded fasteners that can be difficult to turn with a traditional wrench.

Suitable for occasional maintenance work, these sets are imported.

Ratchet mechanisms allow you to turn fasteners in tight spaces without removing and repositioning the tool.

An insulated handle protects against accidental contact with live electrical circuits. These wrenches are tested to 1,000 volts to meet IEC 60900.

The offset head gives you additional clearance to turn hard-to-reach fasteners.

Open the jaws to fit around a fastener like an open-end wrench; close the jaws and the wrench acts like a ratcheting box wrench.

Open the jaws to fit around a fastener like an open-end wrench; close the jaws and the wrench acts like a ratcheting box wrench.

A ratchet mechanism allows you to turn fasteners without removing and repositioning the wrench.

A gasket seals in permanent lubrication and keeps out dirt, dust, and moisture.

Twist the grip to rapidly turn a socket before final tightening or to remove a fastener once loosened. The handle also swings like a traditional ratchet wrench.

Also known as a construction or spud handle, wrenches use the pointed end to align bolt holes.

Made of aluminum-bronze, these wrenches satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present.

Rather than teeth, these wrenches use a series of rollers to engage the ratchet, enabling work in the tightest of spaces. Also known as silent ratchets, they don't make the traditional click sound when turned.

The 20° offset head provides clearance when reaching over obstructions.

The ratcheting mechanism turns sockets quickly.

Position the head anywhere along the handle.

Pivot the head for access to fasteners in tight spots.

When the set torque is reached, these wrenches signal with an audible click and an impulse in the grip.

Insulated to protect against accidental contact with live electrical circuits, these wrenches are tested to 1,000 volts to meet IEC 60900.

No need to pull the socket off the tool—push a button to release.

Turn sockets from above when there's not room to swing a standard wrench handle.

Set the desired torque and the wrench indicates when it's reached with an audible click and an impulse in the grip.

Measure with an accuracy of ±2%.

Built for durability, these high-performance tools handle the demands of high-volume production and tough maintenance applications.

These tools are suitable for general shop, maintenance, and automotive work.

A ratchet mechanism in the head allows you to turn fasteners in tight spaces without removing and repositioning the wrench.

Break stuck screws free using screwdriver bits. Strike the end of the handle with a hammer to turn the bit and tighten or loosen fasteners.

These tools deliver powerful rotational blows to maximize torque and drive screws quickly, even through thick or dense material.

The motor shuts off when the set torque is reached to provide the most torque control of any air-powered screwdriver.

Set torque and the clutch slips to prevent you from exceeding it.

Adjust the nosepiece to set the depth and prevent fasteners from being driven too deep. These drivers are good for use with soft materials such as wood, fiberboard, drywall, and insulation board. They are powered by rechargeable batteries.