A lever reverses the ratchet direction.

A lever reverses the ratchet direction.

Flip these wrenches over to ratchet in the opposite direction.

Made in the U.S.A., these tools handle the toughest industrial applications, provide the best grip on fasteners, and have a superior finish.

Flip these wrenches over to ratchet in the opposite direction.

Made in the U.S.A., these tools handle the toughest industrial applications, provide the best grip on fasteners, and have a superior finish.

A spline-shaped box end turns spline, hex, and 12-point fasteners. This shape also gets a better grip on rounded fasteners that can be difficult to turn with a traditional wrench.

A ratchet mechanism allows you to turn fasteners in tight spaces without removing and repositioning the wrench.

An insulated handle protects against accidental contact with live electrical circuits. These wrenches are tested to 1,000 volts to meet IEC 60900.

The offset head gives you additional clearance to turn hard-to-reach fasteners.

Open the jaws to fit around a fastener like an open-end wrench; close the jaws and the wrench acts like a ratcheting box wrench.

A ratchet mechanism allows you to turn fasteners in tight spaces without removing and repositioning the wrench.

A ratchet mechanism allows you to turn fasteners without removing and repositioning the wrench.

No need to pull the socket off the tool—push a button to release.

The shaft on these wrenches extends and locks.

Insulated to protect against accidental contact with live electrical circuits, these wrenches are tested to 1,000 volts to meet IEC 60900.

A gasket seals in permanent lubrication and keeps out dirt, dust, and moisture.

Made of aluminum-bronze, these wrenches satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present.

The 20° offset head provides clearance when reaching over obstructions.

Position the head anywhere along the handle.

A rubber coating provides a comfortable grip.

Bend around obstructions to turn hard-to-reach fasteners.

These wrenches slip to disengage and stop turning the fastener when the set torque is reached, preventing overtightening.

Measure with an accuracy of ±2%.

When the set torque is reached, these wrenches signal with an audible click and an impulse in the grip.

These wrenches have an accuracy of ±2.0%.

Unlike most torque wrenches, you don’t have to return the torque setting to the lowest value after use. These tools are also known as split-beam torque wrenches.

No need to pull the socket off the tool—push a button to release.

Use these tools for general shop applications.

Built for durability, these high-performance tools handle the demands of high-volume production and tough maintenance applications.

A ratchet mechanism in the head allows you to turn fasteners in tight spaces without removing and repositioning the wrench.

Set torque and the clutch slips to prevent you from exceeding it.

Adjust the nosepiece to set the depth and prevent fasteners from being driven too deep. These drivers are good for use with soft materials such as wood, fiberboard, drywall, and insulation board. They are powered by rechargeable batteries.

The motor shuts off when the set torque is reached to provide the most torque control of any air-powered screwdriver.

Connect these powerful tools to your shop air. They hammer as they rotate to drive screws quickly, even through thick or dense material.

Break stuck screws free using screwdriver bits. Strike the end of the handle with a hammer to turn the bit and tighten or loosen fasteners.