Mounting brackets let you attach them to a wall or other vertical surface.

To spin your reel in any direction, use swivel mounts. Attach them to a flat surface, reel stand, or mounting bracket.

These electric grippers pick and place items in machine-tending, assembly, and packaging applications without the need for compressed air. They are FANUC approved and include a robot tool mount, electrical connectors, and a software plug-in, so they’re ready to attach to your CRX robot and quick to set up. All have a servomotor that opens and closes the grippers with equal force to grasp and release items from the inside or outside.

These grippers have four set gripping forces to move items—use a screwdriver to select the force you’ll need. Since these grippers open and close at the same force and stroke with every cycle, they’re good for picking items of a similar size and material. A discrete I/O signal and included inductive proximity sensor send information about an item’s location to your robot arm. These grippers are rated IP30 to prevent objects greater than 2.5 mm, such as a screwdriver, from making contact with live circuits. They don't have any pinch points or sharp edges, so they help you meet ISO/TS 15066 international safety standards.

See additional pick-and-place grippers and tool mounts to customize your setup.

Connect fingers to your gripper and start moving items. Made of lightweight but strong nylon, all have rubber gripping pads to protect items from damage.

Warning: Never use to lift people or items over people.

These lifter kits pick and place items from one surface to another using suction created by electricity—a good option when compressed air isn't available. They are FANUC approved and include a robot tool mount, electrical connectors, and a software plug-in, so they’re ready to attach to your CRX robot and quick to set up. Use them for material handling applications, such as moving items between conveyor belts. Check their status and adjust the vacuum levels directly on the lifter. The integrated vacuum sensor sends information about an item's position to your controller and triggers LED status indicators that show whether the arm is picking it up or releasing it. These lifters have near-field communication (NFC), so you can use a smartphone to read data, instructions, and error messages when you’re near the arm. Rated IP40, they're protected from objects greater than 1 mm from coming into contact with live circuits. They don't have any pinch points or sharp edges, so they help you meet ISO/TS 15066 international safety standards.

See additional vacuum lifters to customize your setup.

Elevate robot arms with these pedestals so they can reach onto raised surfaces, such as conveyor belts or workstations. Made from steel, they are strong and built to last. Secure them to the ground or other flat surface using the holes in the bottom plate. Additional holes are designed to level the pedestals—thread fasteners (not included) through each hole and adjust their depth to compensate for uneven floors. All of these pedestals have cable routing holes, so you can feed cables, wires, and tubes through the center column to keep your cables organized and out of the way. Additional pedestals offer customizable mounting and mobility.

These pedestals are only for use at collaborative speeds. They are not designed for robots moving at high speeds.