Mount these externally threaded shafts into tapped holes rather than using a shaft support, or attach a hex nut, shaft collar, or other threaded accessory.

Also known as single-start and self-locking lead screws and nuts, these have a single thread that runs the length of the screw. The nut travels only when the screw turns, so your system won't unexpectedly move when the lead screw is at rest.

Designed for use with right-hand, externally threaded rod ends, these rods have right-hand threads on both ends. Use them for remote valve operators, throttle controllers, shifting mechanisms, and virtually any push/pull assembly.

An economical alternative to Grade B7 and Grade B16 threaded rods, these metric Class 8.8 rods are suitable for fastening most machinery and equipment.

About half the strength of medium-strength steel threaded rods, use these metric fine-thread rods for light duty hanging, mounting, and fastening.

These metric 316 stainless steel threaded rods are more corrosion resistant than 18-8 and 410 stainless steel threaded rods and have excellent resistance to chemicals and salt water.

These metric brass threaded rods are corrosion resistant in wet environments, electrically conductive, and nonmagnetic.

Also known as tap-end, fixture, and setup studs, these studs have Class SK6 friction-fit threads on one end to resist loosening and Class 6g standard threads on the other end for attaching a nut.

These steel studs are zinc plated to resist corrosion in wet environments.

316 stainless steel studs have excellent resistance to chemicals and salt water.

Choose these locknuts to fasten standard metric threads. They’re Class 8 steel, so they can be used in most fastening applications.

Plastic coupling nuts are chemical resistant, nonconductive, and lightweight.

Brass coupling nuts are corrosion resistant in wet environments and electrically conductive.

Known for their strength, steel coupling nuts are available with a corrosion-resistant finish.

A nylon patch bonded to the threads adds friction, preventing these standoffs from loosening from vibration.

The magnetic end of these standoffs makes it easy to temporarily mount or reposition components on magnetic surfaces.

A recess under the hex clinches a panel for a strong hold that won't push, pull, or twist out. When mounted with a lever press, the hex sits flush with the surface and the open end creates a through hole.

Increase or decrease metric thread size from one male-threaded part to another. Commonly used to connect two differently sized threaded rods, they have a hex-shaped body, so you can tighten them with a standard wrench.