Vertical Center-Locating Punches for Curved Surfaces
Align the level to find and mark the vertical center of curved surfaces.
Body | ||||||||
|---|---|---|---|---|---|---|---|---|
| For Dia. | Point Dia. | Lg. | Wd. | Ht. | Punch Material | Features | Each | |
| 5/8"-8" | 9/32" | 1 7/8" | 1 1/2" | 1" | Steel | Bubble Level | 0000000 | 000000 |
Center-Locating Punches for Curved Surfaces
Locate and mark the centerline on rods, tubes, and pipes, lay out keyways, and establish angles for connections.
Manual locator is for use with a hammer. Gently strike the rod to mark the center.
Spring-loaded locator marks the center with the pull of a trigger.
| Punch Operation | Angle Measuring Range | Graduation Marks | Numeric Increments | For Min. Pipe OD | Material | Punch Material | Includes | Features | Each | |
| Manual | 0°-90° | 2.5° | 10° | 1/2" | Aluminum | Steel | Adjustable Dial Protractor | Bubble Level | 000000 | 0000000 |
| Spring Loaded | 0°-90° | 2.5° | 10° | 1" | Aluminum | Steel | Adjustable Dial Protractor | Bubble Level | 000000 | 000000 |
| Replacement Dial/Level Assembly | 0000000 | Each | 000000 |
Center Finders for Curved Surfaces
Center your work by mounting these into your drill chuck or collet and lining up the pointer with the mark on the shaft.
| For Max. Dia. | Material | Each | |
| 5" | Chrome-Plated Steel | 00000000 | 000000 |
Starrett Swivel-Joint Center Finder Sets
Determine tool spindle position in relation to work surface, layout lines, holes, and slots. Also known as wiggler sets. Attachments are interchangeable.
| Includes | Material | Each | |
| 0.10" Diameter Disc Contact, 0.25" Ball Contact, Chuck, Needle Point, Offset Indicator Holder | Steel | 0000000 | 000000 |