From cookware to chemical-processing equipment, 304 stainless steel is a good all-around choice for a wide range of applications.

This material has tighter tolerances than standard 304 stainless steel.

Bend this wire and it will stay put. It’s frequently used as tying wire and locking wire.

The textured surface hides fingerprints and dents. This material is widely used in decorative applications, such as partitions and handrails.

This material has tighter tolerances than standard 303 stainless steel.

The addition of molybdenum gives 316 stainless steel excellent corrosion resistance. Use it in a variety of marine and chemical-processing applications.

This material is precision ground to offer tighter tolerances than standard 316 stainless steel.

Bend this wire and it will stay in place. It's widely used as tying and locking wire.

2205 stainless steel resists cracking even when faced with a combination of tensile stress, corrosive chemicals, and heat. Also known as duplex stainless steel, it has twice the strength of 316 stainless steel. Use it for high-pressure applications in caustic environments.

One of the hardest types of stainless steel after heat treating, 440C offers excellent wear and abrasion resistance. It's often used for bearings, valves, and knife blades.

Ready for turning in your lathe, these rods are precision ground to a tight tolerance.

Bend this wire and it will stay in place. It's commonly used as tying and locking wire.

Hardened for superior wear resistance, these rods are precision ground to a tight diameter tolerance so they’re ready for turning in a lathe.

Each piece is precision ground to offer tighter tolerances than standard 17-4 PH stainless steel.

This material is hardened for improved strength and wear resistance.

With a higher chromium content than 15-5 PH stainless steel, this high-strength 17-4 PH offers better corrosion resistance. It is also known as 630 stainless steel.

13-8 PH stainless steel can be hardened at lower temperatures than other heat-treatable types of stainless steel. It is widely used for fittings, pins, and lock washers.

309/310 stainless steel has high levels of chromium and nickel to provide good corrosion resistance at elevated temperatures. It's often used in heat exchangers and furnaces.

Combine these general purpose drive shafts with gears, sprockets, and bearings to transmit rotary motion.

These shafts have keyways only on the ends, leaving a plain shaft in the center. Use the keyways with machine keys to transmit torque to gears, sprockets, and other keyed components. Use the middle of the shaft with bearings and other round-bore components.

The diameter of these shafts is slightly smaller than listed, so precision ball bearings (ABEC-3 and above) slide on without any tools.

Combine these general purpose shafts with a linear bearing and shaft support to create a basic linear motion system.

Replace worn shafts in two-piece support-rail shaft systems, or mate with a support rail to create your own. The tapped mounting holes match those on our Support Rails.

One end of these shafts is machined to fit into the mixer; the other is machined to fit into an attachment like a propeller.

Keep a variety of lengths of pipe and pipe nipples on hand for areas where corrosion is a concern.

These shafts have one threaded end to fit threaded propellers and one machined end to fit mixer shaft couplings.

Typically used with medium- to high-pressure stainless steel threaded pipe fittings.

Typically used with thick-wall and high-pressure stainless steel unthreaded pipe fittings.