The grit particles are block shaped and cut slowly.

The mesh in these sanding pads flexes to compensate for uneven pressure as you sand, producing a consistent finish.

When you need to achieve a more consistent finish, choose nylon mesh sanding rolls over paper- or cloth-backed rolls.

Use these rolls to create consistent finishes on hard metals such as stainless steel, iron, and nickel.

Holes allow dust removal when used with a vacuum sander to prevent buildup of debris on the abrasive surface.

The cushioned construction gives you more control over sanding pressure, creating finer and more consistent finishes.

The nylon mesh on these discs is embedded with precision-shaped ceramic alumina, which cuts through hard metals like stainless steel faster than other forms of ceramic alumina because of its sharp, outwardly pointed grit.

When you need to achieve a more consistent finish, choose nylon mesh sanding discs over paper- or cloth-backed discs.

The nylon mesh on these discs is embedded with precision-shaped ceramic alumina, which cuts through hard metals like stainless steel faster than other forms of ceramic alumina because of its sharp, outwardly pointed grit.

The premium abrasive stays sharp longer.

When you need to achieve a more consistent finish, choose nylon mesh sanding discs over paper- or cloth-backed discs.

The premium abrasive stays sharp longer.

The ceramic alumina abrasive on these discs is sharp and dense enough to shape hard metals such as stainless steel, nickel, and cast iron without dulling quickly.

The premium abrasive stays sharp longer. Holes in the disc let you see the surface you’re sanding.

Prepare material surfaces for finishing processes such as coating, painting, and soldering—these discs contain an extra coarse ceramic alumina abrasive for heavy cleaning and stripping of stainless steel, nickel, and other hard metals.

With more flaps than standard discs, these last 30-40% longer.

Replace your sanding discs less often—the backing plate on these discs can be trimmed off as the abrasive flaps wear down, allowing you to use more of the disc.

The flaps wrap around the outer edge of these discs to sand welds at right angles.

Set at an angle and widely spaced, the flaps reach into corners.

These belts last at least 50% longer and sand faster than standard ceramic alumina belts.

When you need to achieve a more consistent finish, choose nylon mesh sanding belts over paper- or cloth-backed belts.

Coated with ceramic alumina abrasive, these rolls are sharp and dense enough to shape hard metals such as stainless steel, nickel, and cast iron without dulling quickly.

The ceramic alumina abrasive on these pads is sharp and dense enough to shape hard metals such as stainless steel, nickel, and iron without dulling quickly.

The threaded stud allows faster wheel changes but requires the use of an adapter in your tool.

Lap without the mess of pastes and slurries—abrasive is embedded in the surface of this waterproof film.