McMaster-Carr logo
    Forward
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Print
    How can we improve?
    Comments
    E-mail address (if you would like a response)
    15 Products

    Plywood Scaffold Planks

    Image of Product. Front orientation. Scaffold Planks. Plywood Scaffold Planks.
    Image of Attribute. Side1 orientation. Contains Annotated. Scaffold Planks. Plywood Scaffold Planks.
    The most commonly used and cost-effective planking for scaffolding walkways. Install three of these planks side-by-side to create a full platform atop standard 5 ft. wide scaffold frames. Hooks with a 2" opening at each end secure these planks to end frames. Their plywood walking surface can be replaced with standard 5/8" thick plywood when worn.
    Note: Length is measured from center-to-center of end hooks.
    Note: Planks meet OSHA dimensional standards. Users are responsible for checking local, state, and federal codes, including OSHA, for safe installation and operating practices.
    Rail
    Lg.,
    ft.
    Wd.
    Ht.
    Wt. Cap.,
    lb.
    Plank
    Tread
    Ht.
    Material
    Wt.,
    lb.
    Assembly
    Features
    Specs. Met
    Each
    719"4"1,000Smooth4"Aluminum
    		34Assembled2" End HooksANSI/ASSP A10.8, Cal/OSHA Compliant Title 8 Section 1637, Cal/OSHA Compliant Title 8 Section 1646, OSHA Compliant 29 CFR 1926.4518180T160000000
    819"4"750Smooth4"Aluminum
    		42Assembled2" End HooksANSI/ASSP A10.8, Cal/OSHA Compliant Title 8 Section 1637, Cal/OSHA Compliant Title 8 Section 1646, OSHA Compliant 29 CFR 1926.4518180T17000000
    1019"4"1,000Smooth4"Aluminum
    		46Assembled2" End HooksANSI/ASSP A10.8, Cal/OSHA Compliant Title 8 Section 1637, Cal/OSHA Compliant Title 8 Section 1646, OSHA Compliant 29 CFR 1926.4518180T18000000

    Scaffold Guardrails

    Image of ProductInUse. Front orientation. Contains Annotated. Scaffold Guardrails.
    Image of Product. Front orientation. Scaffold Guardrails.
    Add a barrier around your scaffold platform to prevent falls. These guardrails attach to posts (not included) on the edge of your platform. You can also replace sections of an existing barrier to make sure your scaffold meets safety requirements. Made of galvanized steel, these guardrails resist rust and hold up to outdoor use.
    Note: Guardrails meet OSHA and Cal/OSHA dimensional and construction standards. Check local, state, and federal codes, including OSHA, for safe set up and operating practices.
    Mounting
    Lg.,
    ft.
    OD
    Material
    Wt.,
    lb.
    Hardware
    Included
    No. of
    Holes
    Hole
    Dia.
    Specs. Met
    Each
    End Rails
    51"Galvanized Steel3No29/16"Cal/OSHA Compliant Title 8 Section 1646, OSHA Compliant 29 CFR 1910.29, OSHA Compliant 29 CFR 1926.4517665N11000000
     
    Side Rails
    71"Galvanized Steel5No29/16"Cal/OSHA Compliant Title 8 Section 1646, OSHA Compliant 29 CFR 1910.29, OSHA Compliant 29 CFR 1926.4517665N1200000
    101 1/4"Galvanized Steel9No29/16"Cal/OSHA Compliant Title 8 Section 1646, OSHA Compliant 29 CFR 1910.29, OSHA Compliant 29 CFR 1926.4517665N1300000
     

    Plywood Scaffold Planks with Access Door

    Image of Product. Front orientation. Scaffold Planks. Plywood Scaffold Planks with Access Door.
    Image of Attribute. Side1 orientation. Contains Annotated. Scaffold Planks. Plywood Scaffold Planks with Access Door.
    Safely climb inside your scaffold when surrounding space is tight. These planks have an access door that swings open to reach your work platform. They’re made of plywood—the most commonly used and cost-effective planking material for scaffolds. Hooks at each end secure these planks to end frames. Length is measured from center-to-center of the end hooks.
    Note: Planks meet OSHA and Cal/OSHA dimensional and construction standards. Check local, state, and federal codes, including OSHA, for safe set up and operating practices.
    Use an additional plank (sold separately) to create a platform that spans a standard 5 ft. wide scaffold. They do not include an access door.
    Scaffold Planks
    Additional
    Planks
    Rail
    Lg.,
    ft.
    Wd.
    Ht.
    Wt. Cap.,
    lb.
    Plank
    Tread
    Ht.
    Material
    Wt.,
    lb.
    Assembly
    Features
    Specs. Met
    Each
    Each
    728"3 1/2"1,200Smooth3 1/2"Aluminum
    		43Assembled2" End Hooks, Access DoorANSI/ASSP A10.8, Cal/OSHA Compliant Title 8 Section 1637, Cal/OSHA Compliant Title 8 Section 1646, Cal/OSHA Compliant Title 8 Section 3622, OSHA Compliant 29 CFR 1926.4518104N1300000008104N110000000
    1028"4 1/2"1,100Smooth4 1/2"Aluminum
    		55Assembled2" End Hooks, Access DoorANSI/ASSP A10.8, Cal/OSHA Compliant Title 8 Section 1637, Cal/OSHA Compliant Title 8 Section 1646, Cal/OSHA Compliant Title 8 Section 3622, OSHA Compliant 29 CFR 1926.4518104N140000008104N12000000

    Uneven Surface Scaffolds

    Image of System. Shown Assembled. Front orientation. Contains Annotated. Scaffolds. Uneven Surface Scaffolds.
    Image of ProductInUse. Front orientation. Contains Border. Scaffolds. Uneven Surface Scaffolds.

    Shown Assembled

    Even if your surface isn't level, your scaffold can be—the end frames on these scaffolds adjust independently so you can set each side at a different height. You can change the plank height in 4" increments; use the spring-loaded pins to lock it in place.
    Note: Scaffolds meet OSHA dimensional standards. Users are responsible for checking local, state, and federal codes, including OSHA, for safe installation and operating practices. Scaffolds also meet CAL-OSHA standards, which is required for use in California.
    Guardrail/Toeboard Kits
    Guardrail/toeboard kits are required by OSHA when add-on height sections are used.
    Overall
    Lg., ft.
    Guardrail
    Ht.
    Toeboard
    Ht.
    Color
    Assembly
    Specs. Met
    Each
    Powder-Coated Steel
    640"3"YellowUnassembledANSI/ASSP A10.8
    Cal/OSHA Compliant Title 8 Section 1646
    OSHA Compliant 29 CFR 1910.29    		8069T140000000
    840"4"YellowUnassembledANSI/ASSP A10.8
    Cal/OSHA Compliant Title 8 Section 1646
    OSHA Compliant 29 CFR 1910.29    		8069T22000000
     

    Build-Your-Own Scaffolds

    Image of System. Front orientation. Contains Annotated, Inset. Scaffolds. Build-Your-Own Scaffolds.
    Mix and match these components to build a scaffold that suits your job. All components are compatible with each other, but they can’t be combined with other scaffold systems. They can be used indoors or outdoors. Add scaffold inspection tags to show whether a scaffold is under construction or ready for use.
    Note: Scaffold components meet OSHA and Cal/OSHA dimensional and construction standards. Check local, state, and federal codes, including OSHA, for safe set up and operating practices.
    Toeboards
    Image of Product. Toeboards. Front orientation. Contains Annotated. Scaffolds. Build-Your-Own Scaffolds, Toeboards.
    Image of Product. Toeboards. Front orientation. Scaffolds. Build-Your-Own Scaffolds, Toeboards.

    Toeboards

    Toeboards

    Use toeboards to create a raised edge around the platform so you don’t accidentally knock tools off the side.
    Ht.
    Lg.,
    ft.
    Wt.,
    lb.
    Specs. Met
    Each
    Galvanized Steel
    6"511Cal/OSHA Compliant Title 8 Section 1646
    OSHA Compliant 29 CFR 1910.29
    OSHA Compliant 29 CFR 1926.451    		8742N32000000
    6"1020Cal/OSHA Compliant Title 8 Section 1646
    OSHA Compliant 29 CFR 1910.29
    OSHA Compliant 29 CFR 1926.451    		8742N3400000
    6"8414Cal/OSHA Compliant Title 8 Section 1646
    OSHA Compliant 29 CFR 1910.29
    OSHA Compliant 29 CFR 1926.451    		8742N3300000
     
    back to top