Take your maintenance and repair tasks to new heights—these scissor lifts were built for reliability. Each part has been inspected and tested to ensure these lifts remain in service for over a decade. They’re designed to minimize hydraulic connections and cylinders to reduce failure points. Powered by a brushless motor, there’s no need for regular maintenance. Even the operation is no fuss—a single joystick controls both driving and elevation.

Their compact size and tight turning radius let you navigate through standard doorways and crowded spaces. Suitable for indoor and outdoor use, they’re made of powder-coated steel parts—even the pins and screws—and have waterproof connectors that stand up to the elements. Pothole guards keep them from tipping on uneven surfaces.

The platform supports up to 500 lbs. and is wide enough for two people to work comfortably side-by-side. Guardrails on each side meet fall-protection requirements. With three fall-restraint tie-off points, you have additional spots to anchor fall protection gear.

Note: Check local, state, and federal codes, including OSHA, for safe operating practices. Do not operate these lifts in winds over 25 mph. When used outdoors, only one person should be on them at a time.

These scaffolds provide the space and height to complete elevated projects that most work platforms can't reach. Height adjusts in 2" increments. Powder-coated steel means these scaffolds can be used outdoors and in damp areas.

Note: Scaffolds meet OSHA dimensional standards and CAL-OSHA standards for use in California. Users are responsible for checking local, state, and federal codes, including OSHA, for safe operating practices.

Build tube-and-clamp scaffolding and attach supports, such as railings, to frame-style structures. Also known as knuckles. These clamps fit the most common scaffold tube sizes. Made of galvanized steel, they are rust resistant and hold up in outdoor applications.

Swap these jacks with the base plates on your scaffold to create a level foundation on uneven ground. They adjust in increments less than an inch, so you can set each leg of your scaffold to the exact height you need. Made from galvanized steel, these jacks resist rust and hold up to outdoor use. For safety and stability, the top 6" of the threaded stud slides into the scaffold frame and isn’t usable.

Note: Leveling jacks meet OSHA and Cal/OSHA dimensional and construction standards. Check local, state, and federal codes, including OSHA, for safe set up and operating practices.