These stops have a metal stem and base for strength and durability. Use them to protect walls from doors in high-traffic applications. All have a rubber pad, which is abrasion resistant. Mount them with the included screws.

Remove the pin on your door's hinge, slide it through one of these stops, and then insert it back into the hinge to set and adjust the door's opening angle. Both stops have nonmarking rubber pads, which are abrasion resistant. Use the locking screw or threaded stud to make your adjustments.

Simply screw these bumpers into baseboards with the attached self-tapping wood screw to prevent doors from damaging walls. All of these stops have a nonmarking rubber pad, which is abrasion resistant.

Press these silencers into a drilled hole in the door frame. Doors close firmly yet quietly with these silencers. They also eliminate the rattling of doors against their frames. Made of rubber, they are abrasion resistant. They require _1/8" of clearance between the door and the frame.

Protect door knobs and other hardware from damage caused by carts, dollies, and other equipment. Mount these bumpers on doors next to, above, below, or over the item you wish to protect. Install them with screws. They are stainless steel for excellent corrosion resistance, making them a good choice for harsh environments. They also have good chemical resistance.

Keep sliding doors and panels from damaging walls and door frames. Mount these stops with screws.

Mount one end to the frame and the other end to the door to prevent it from opening too far.

Protect large swinging doors where carts and vehicles are used to push the door open. These plastic bumpers are commonly used on two-way swinging doors. All are chemical resistant and won't dry out and become brittle when exposed to UV rays. Mount with the included screws.