Eliminate sharp bends at the end of your air and water hose—these fittings have a built-in kink absorber.

With just a vise and a wrench, make or repair hose assemblies in the field.

Hose has good oil-resistance, so it won’t deteriorate or become brittle when exposed to grease and lubricants.

You don't need a clamp to secure these fittings to tubing. They have a nut on the barbed end that tightens to hold the tubing in place.

A built-in shut-off valve stops airflow when the fittings are disconnected from tubing.

Made of nickel-plated brass, these fittings have better corrosion resistance than unplated brass fittings.

These fittings won’t absorb moisture, so they’re good for water and high-humidity air applications.

These fittings keep their strength in moist environments and meet NSF/ANSI 61 for drinking water. Also known as instant fittings.

Connect these fittings to tubing with a ring and a crimping tool (both sold separately). Safe to use with drinking water, these fittings meet the strict standards of NSF/ANSI 61.

Also known as instant fittings, these chemical-resistant plastic fittings connect to tubing with a push. An internal gripping ring holds the tubing tight.

Distribute air or fluid to multiple locations from a single supply source with these manifolds. They are also known as headers.

Designed for ultra-clean environments, these manifolds are cleaned, dried, and vacuum sealed in plastic to prevent dirt and moisture from contaminating the inside. Use them to distribute air or fluid to multiple locations from a single supply source. Also known as headers.

When you’re short on vertical space, these manifolds are a good fit—they have outlets on the side instead of on top, so they have a lower profile than rectangular manifolds. Use them to distribute air or fluid to five locations from a single supply source.

With outlets on the side instead of on top, these manifolds have a lower profile than rectangular manifolds and fit well in cramped spaces. Use them to distribute air or fluid to three locations from a single supply source.

These junction blocks have threaded holes that allow air or fluid to flow at a 90° angle through the block. Use them to organize and separate multiple lines in your system.