Made from PTFE, these wear rings have a slippery surface that allows rods to move at least three times faster than nylon wear rings.

Aramid and PTFE fibers are blended for seals that resist chemicals and abrasion. Use these seals in pumps.

Also known as 100% GFO, these expanded PTFE seals contain graphite powder, which dissipates heat away from the shaft and allows pumps to run cool at high speeds.

Use these graphite-impregnated graphite seals for steam applications in pumps and valves.

The most abrasion resistant of all our packing seals, these are made of PTFE-impregnated aramid fiber that has been saturated in a lubricant. They are for use in pumps.

For use in valves and pumps, this thin, flexible tape is made from high-purity graphite with no fibers or binders that could contaminate your process line.

These loosely knitted fiberglass seals are more flexible, compressible, and conformable than High-Temperature Rope Edge Seals.

These loosely-knitted fiberglass seals are more flexible and conformable than High-Temperature Slotted Edge Seals. They resist grease, oil, hydraulic fluid, and solvents and can withstand temperatures up to 1000° F.

Softer than standard Viton® fluoroelastomer O-rings, these offer a better seal in low-pressure applications.

These temperature- and chemical-resistant O-rings prevent leaks in tube fittings that have a straight-thread connection, also known as O-ring boss fittings.

Unlike silicone, the Viton® fluoroelastomer core will continue to ward of chemicals should the FEP casing wear away.

Able to bounce back after repeated compression, these Kalrez 7075 O-rings last longer than other Kalrez O-rings when exposed to repeated heating/cooling cycles.

Also known as Boss O-rings, these Kalrez 4079 O-rings are for use in tube fittings with a straight-thread connection. They’re inherently softer and more compressible than PTFE O-rings with comparable chemical resistance.

The X shape of this cord stock provides four points of contact for a better seal in dynamic applications than round profile. It also requires less compression to make a seal, so it offers a longer service life.

This cord stock is softer and creates a better seal than standard silicone cord stock in low-pressure applications up to 400° F.

In addition to water and steam, this EPDM cord stock resists diluted salt solutions, ethanol, and isopropyl alcohol.

These 325-piece assortments mean you’ll always have a backup ring on hand.

Thinner than non-sagging sealants, these flow easily into cracks and have a smooth finish.