Startle intruders and draw attention to activity in remote areas without access to power—these solar-powered lights shine bright when motion is detected. They charge during the day, and the battery lasts all night with typical activity. If triggered continuously, these lights reduce brightness to last six hours on a full charge. Rated for use in wet locations, they hold up in rain and humidity.

Mount these lights about 8 ft. high on exterior walls. For maximum sunlight exposure, place the solar panel on a roof or wall.

Lights with two heads can also be set to turn on at dusk and run continuously for up to six hours, even if no motion is detected. They include a stake for installing the solar panel in the ground.

Point these lights toward paths, doorways, and other dark areas. Since they run on batteries, you can skip the hassle of running wires. They only turn on when they sense motion, so the batteries last longer than they do in lights that are always on. These lights are rated IP06—they’re sealed for protection from wet weather.

See what’s happening outside your facility—day and night. These lights have a built-in video camera that records when they sense motion. When it’s dark, the LED heads activate at the same time to illuminate the area. The speaker has two-way audio, so you can talk to the person on camera. You can also blast a siren through the speaker to deter a potential intruder. Rated for use in wet locations, these lights hold up to rain and humidity.

Download the free app to your mobile device to control these lights via Wi-Fi. Use the app to adjust settings, set up notifications, schedule lights to turn on and off, and review footage. Because videos are stored on the included 128 GB microSD card, you don’t need to pay for a subscription to view them. The app alerts you when storage is low. If it runs out, new videos record over the oldest ones.

Hang these lights in garages and covered walkways to create a safe, well-lit path. They’re also known as canopy lights. All are either UL or ETL Listed for use in wet locations. Select a light appearance to match your existing lighting. If you’re not sure what temperature you need, choose a light with a selectable light appearance. You can adjust the temperature with a switch.

Fasten these lights to a ceiling or to an outlet box. Styles A-C can also be suspended like a pendant from conduit.

Lights with a light sensor automatically turn on in low light conditions. Lights with a motion sensor stay dim until movement is detected, saving energy.

Lights rated IP65 are sealed to keep out dust and driving rain.

Bring light to your parking lot or walkway in minutes—these lights come wired and already attached to a lightweight pole. All you have to do is unfold the light head and secure it with a single screw, mount the pole to your existing anchor bolts, and connect them to your power source. The baseplate works with common anchor bolt patterns. If you don’t have existing anchor bolts, set the included ones in concrete.

Once these lights are up and running, a light sensor turns them on at dusk and off at dawn. A motion sensor brightens them when someone walks by at night, and they’ll dim again after 30 minutes of inactivity. Download the free app to your mobile device to adjust the light and motion sensor settings via Bluetooth.

Choose lights with one head for roadways and the edges of parking lots. Choose lights with two heads for the center of parking lots and other large areas.

16 ft. high lights are rated for 3 second wind gusts up to 120 mph per AASHTO specifications. They meet wind zone standards for all inland and U.S. coastal areas except South Florida. 20 ft. high lights are rated for 3 second wind gusts up to 90 mph per AASHTO specifications. They meet inland wind zone standards.