These switches use DC input voltage and produce PNP or NPN signal output. They're often used with programmable logic controllers (PLCs).

Easily mount these flat switches to a base or rail.

The flexible cable on these switches withstands applications that require frequent motion, such as robotics.

Mount these intrinsically safe switches to flat surfaces in volatile areas. Their low-current, low-voltage NAMUR signal means they won’t ignite or create sparks while in use. ATEX and IECEx certified, they meet international standards to protect against explosion where combustible dust and flammable gases are present.

Turn the face on these switches to sense metallic objects from the front, sides, top, or bottom.

These inductive proximity switches sense metallic objects each time they pass through the slot, even when they’re obscured by water, oil, dirt, or a surface finish. Use them to measure the speed of rotating equipment and to count or detect moving objects, such as sheet metal being fed into a stamping process.

Check the position of your torch or workpiece for accuracy during robotic welding.

Sense objects as they pass through the switch’s ring via tubing or a funnel. These switches are often used to monitor blockages, detect breaks in spooling wire, or count small metallic parts, such as screws, during the stamping process.

These switches have a longer sensing distance compared to other proximity switches with the same diameter.

Mount these flat inductive switches to a base or rail to remotely detect metallic objects in wet and dirty environments.

Switches accept both AC and DC input voltage.

Detect the presence or absence of an object moving at high speeds with a light beam. These switches have a longer sensing distance than proximity and ultrasonic switches.

These switches have a receiver built into the housing, eliminating the need to align components and measure sensing distance during installation.

Set these switches to delay activation by up to fifteen seconds after detecting an object.

Detect objects as thin as a freshly sharpened pencil tip. These switches are best for tight spaces because they have a smaller light beam and can detect smaller objects than standard photoelectric switches.

About half the size of standard photoelectric switches, these switches are good for use in tight spaces. They detect objects moving at high speeds with a light beam.

A slim design and a light beam that’s angled upwards allow these switches to sense objects from between conveyor rollers.

Often used with programmable logic controllers (PLCs), these switches use DC input voltage and produce PNP or NPN signal output.

Switches accept both AC and DC input voltage.

These switches sense when a valve is open or closed, supporting flow and temperature control within your system and offering reliable feedback.

Monitor the color of products as they pass by on your line. These transmitters don’t just detect if color is in mint condition—they also turn equipment on or off, all with a single device.

Detect when oil rises on water, foam forms on beer, and tanks empty, triggering pumps and valves in food and sanitary lines. These switches are 3-A and European Hygienic Engineering and Design Group (EHEDG) certified since they’re easy to keep clean.