Sense objects from farther away than with other DC proximity switches that have the same diameter.

Eliminate the need to calculate the sensing distance when using different metals—these switches sense all metal at the same distance. Also known as K=1 sensors.

The flexible cable on these switches withstands applications that require frequent motion, such as robotics.

Use these switches to sense metallic objects in environments containing flammable gases and combustible dust. ATEX and IECEx certified to protect against explosion, they produce a low-current, low-voltage NAMUR signal, so they won’t ignite or create sparks.

Turn the face on these switches to sense metallic objects from the front, sides, top, or bottom.

These inductive proximity switches sense metallic objects each time they pass through the slot, even when they’re obscured by water, oil, dirt, or a surface finish. Use them to measure the speed of rotating equipment and to count or detect moving objects, such as sheet metal being fed into a stamping process.

Check the position of your torch or workpiece for accuracy during robotic welding.

Sense objects as they pass through the switch’s ring via tubing or a funnel. These switches are often used to monitor blockages, detect breaks in spooling wire, or count small metallic parts, such as screws, during the stamping process.

For use in volatile areas, these intrinsically safe switches detect objects when they pass through the slot. They use a NAMUR signal to operate at a low current and voltage, so they won’t ignite or create sparks. ATEX and IECEx certified, they protect against explosion.

Most often found in older devices, these switches require AC input voltage.

Mount these flat inductive switches to a base or rail to remotely detect metallic objects in wet and dirty environments.

Detect the presence or absence of an object moving at high speeds with a light beam. These switches have a longer sensing distance than proximity and ultrasonic switches.

These switches have a receiver built into the housing, eliminating the need to align components and measure sensing distance during installation.

Detect objects as thin as a freshly sharpened pencil tip. These switches are best for tight spaces because they have a smaller light beam and can detect smaller objects than standard photoelectric switches.

The highly flexible fiber-optic cable and small sensing end help you position these switches in hard to reach areas.

Detect irregularly shaped items with a band of light up to 10 times larger than the beam on a standard photoelectric switch.

Spanning up to 230 ft.—roughly the length of a commercial airplane—these safety barrier switches cut power to large machinery to prevent damage or injury.

Maintain sanitary standards—these switches have smooth surfaces without crevices, so they prevent bacteria from building up and are easy to clean.

These switches use a NAMUR signal to operate at a low current and voltage, so they won’t ignite or produce sparks. ATEX certified, they protect against explosion in environments containing flammable gases and combustible dust. Switches sense both metallic and nonmetallic objects.

Rated NEMA 4X, 6P, IP68 and IP69K, these switches resist corrosion and high-pressure, high-temperature washdowns, and can withstand temporary submersion.

Support flow and temperature control in your system with these intrinsically safe switches, which sense when a valve is open or closed in volatile areas. They are ATEX and IECEx certified to protect against explosion.

With a single device, continuously monitor the distance of moving items and turn equipment on and off based on their position.

Measure the level of conductive liquids without drilling a hole in your tank—these switches mount to the outside of the tank and track the capacitance between them and the tank’s contents.

Measure the distance to objects and the level of liquids and materials despite size, shape, or surface finish, and send that information to other parts of your system.