These switches use DC input voltage and produce PNP or NPN signal output. They're often used with programmable logic controllers (PLCs).

Eliminate the need to calculate the sensing distance when using different metals—these switches sense all metal at the same distance. Also known as K=1 sensors.

Mount these intrinsically safe switches to flat surfaces in volatile areas. Their low-current, low-voltage NAMUR signal means they won’t ignite or create sparks while in use. ATEX and IECEx certified, they meet international standards to protect against explosion where combustible dust and flammable gases are present.

These inductive proximity switches sense metallic objects each time they pass through the slot, even when they’re obscured by water, oil, dirt, or a surface finish. Use them to measure the speed of rotating equipment and to count or detect moving objects, such as sheet metal being fed into a stamping process.

These intrinsically safe switches detect objects as they’re routed through the ring. They produce a low-current, low-voltage NAMUR signal, so they won’t ignite or create sparks. Switches are ATEX certified to protect against explosion.

For use in volatile areas, these intrinsically safe switches detect objects when they pass through the slot. They use a NAMUR signal to operate at a low current and voltage, so they won’t ignite or create sparks. ATEX and IECEx certified, they protect against explosion.

Rotate the face on these switches five different directions for easy installation and positioning—they work with both AC and DC inputs.

A built-in relay produces AC voltage output. These switches are often used with older programmable logic controllers (PLCs).

Detect the presence or absence of an object moving at high speeds with a light beam. These switches have a longer sensing distance than proximity and ultrasonic switches.

Rated IP69K, these switches can withstand high-pressure, high-temperature washdowns and temporary submersion.

Set these switches to delay activation by up to fifteen seconds after detecting an object.

About half the size of standard photoelectric switches, these switches are good for use in tight spaces. They detect objects moving at high speeds with a light beam.

A slim design and a light beam that’s angled upwards allow these switches to sense objects from between conveyor rollers.

Often used with programmable logic controllers (PLCs), these switches use DC input voltage and produce PNP or NPN signal output.

Rated NEMA 4X, 6P, IP68 and IP69K, these switches resist corrosion and high-pressure, high-temperature washdowns, and can withstand temporary submersion.

Detect motion near your light fixture to turn lights on and off. Compared to switch-mount motion controls that detect from a single wall, these controls have a better view of the entire space since they sense motion from above.

An infrared light beam senses the lightest finger contact to switch a circuit on or off.

With just a light touch, these switches turn circuits on and off in sanitary areas—even when you're wearing gloves.

Use high-frequency sound waves to detect chemical level.

Measure the level of conductive liquids without drilling a hole in your tank—these switches mount to the outside of the tank and track the capacitance between them and the tank’s contents.