Half the weight of steel, this aluminum framing resists corrosion in wet environments.

Designed with a thin, compact housing, these bearings are good for space-constrained applications.

Used in food, beverage, pharmaceutical, and chemical plants, these mounted ball bearings are IP69K certified for washdown environments and have a two-bolt flange for mounting.

Synthetic grease enables these bearings to operate in temperatures up to 400° F—nearly double the maximum temperature of standard mounted ball bearings with two-bolt flange.

Use these bearings in corrosive environments and under water.

A bolt in each corner makes for a secure, even hold.

The lubricant in these mounted ball bearings is suitable for incidental contact with food.

Made to withstand frequent washdowns, these bearings are permanently lubricated, which means you’ll never have to add lubricant. Use them in hard-to-reach areas in food, beverage, pharmaceutical, and chemical plants.

With a four-bolt flange for mounting and an IP69K certification approving them for washdown environments, these mounted ball bearings are used in food, beverage, pharmaceutical, and chemical plants.

With all three mounting holes on one side, you can position the bearing above or below the mounting surface.

Swap out worn inserts instead of replacing the entire mounted unit.

Designed with a thin, compact housing, these bearings are good for space-constrained applications.

Also known as tapped-base bearings, these ball bearings mount to surfaces from the bottom through threaded holes. Because of their narrow profile, they’re commonly used in tight-clearance spaces, including systems where multiple shafts are mounted close together.

Keep shafts, such as those with a shoulder, clear of the mounting surface. These bearings have a higher mounting base that gives them more space to the mounting surface than standard mounting bases.

Roller bearings have a thinner profile and larger contact area than ball bearings, making them stronger and more space-efficient than ball bearings.

A solid polymer lubricant surrounds the balls, eliminating the need for additional lubrication.

Slip these bearings onto a shaft and secure with the included set screws, no special tools required.