Slide the shaft in to install, then tighten to secure. For use with light to medium loads where shaft alignment is not critical, these shaft supports brace the end of a linear shaft along the ground or other flat surface.

Also known as single-start and self-locking lead screws and nuts, these have a single thread that runs the length of the screw. The nut travels only when the screw turns, so your system won't unexpectedly move when the lead screw is at rest.

An oversized diameter allows for finishing to your exact requirements.

Gray cast iron machines faster with less wear on cutting tools than most types of steel. It's often fabricated into gears, pulleys, rollers, and bushings.

Diameter is oversized to allow for finishing.

Offering excellent antifriction qualities, 932 bronze also offers good strength and wear resistance. It's also known as SAE 660 and is often used for bearings, bushings, and thrust washers.

954 bronze contains a minimum of 10% aluminum for strength and weldability. It is also known as aluminum bronze. It's widely used for bearings, bushings, valve bodies, and worm gears. The strength of this material increases with heat treating.

An easier-to-machine alternative to 932 bronze, 936 also has better corrosion resistance. It's also called modified SAE 64.

Frequently called manganese brass, 863 bronze can handle heavy loads and high speeds when properly lubricated.

The addition of MDS results in a nylon with exceptional wear resistance as well as self-lubricating properties.

This nylon stays lubricated over time because it’s filled with oil. Use it to fabricate parts for hard-to-reach places where adding lubricants would be difficult.

This cast nylon 6 material is easier to machine than other types of nylon. It’s comparable to Nylatron and Nycast.

Use these cast nylon 6 rods to make sheaves, bushings, and pulleys. All withstand higher temperatures and are easier to machine than standard nylon 6/6 rods.