Combine with a machine key to transmit torque to gears, sprockets, and other power transmission components.

Connect these internally threaded shafts directly to threaded components, or use a fastener to secure.

A shoulder near the end of the shaft provides a stop for gears, sprockets, and bearings.

Internal threads allow you to mount these shafts onto threaded studs and fasteners, no shaft supports needed.

A shoulder near the end of the shaft allows for easy positioning of housings, shaft supports, and collars.

Comparable to Grade 8 steel, these threaded rods have a tensile strength of 150,000 psi, making them about 25% stronger than medium-strength steel rods.

Tighten these threaded rods by turning them to the left; once fastened, they resist loosening from counterclockwise motion.

18-8 stainless steel threaded rods have good chemical resistance.

Grade B8 threaded rods meet the pressure and temperature requirements of ASTM A193 and are often used to secure pressure tanks, valves, and flanges. They have good chemical resistance.

Brass threaded rods are corrosion resistant in wet environments, electrically conductive, and nonmagnetic.

Designed for use with right-hand, internally threaded rod ends, these rods have right-hand threads on both ends. Use them for remote valve operators, throttle controllers, shifting mechanisms, and virtually any push/pull assembly.

Similar to turnbuckles, these rods have right-hand threads on one end and left-hand threads on the other so you can make a linkage that adjusts for tension. Add right- and left-hand threaded rod ends to build your linkages.