A flat surface area allows set screws to dig into the shaft for securely mounting gears, sprockets, and bearings.

Connect these internally threaded shafts directly to threaded components, or use a fastener to secure.

Attach threaded accessories, such as mixer propellers and fan blades, to the end of these shafts.

Clip retaining rings into the grooves to separate and position gears, sprockets, and bearings.

Mount these externally threaded shafts into tapped holes rather than using a shaft support, or attach a hex nut, shaft collar, or other threaded accessory.

Clip retaining rings into the grooves to separate and position collars, supports, and housings.

Designed for use with right-hand, externally threaded rod ends, these rods have right-hand threads on both ends. Use them for remote valve operators, throttle controllers, shifting mechanisms, and virtually any push/pull assembly.

Also known as single-start and self-locking lead screws and nuts, these have a single thread that runs the length of the screw. The nut travels only when the screw turns, so your system won't unexpectedly move when the lead screw is at rest.

To remove these pins, thread a screw or tool into the tapped hole, then pull them out.

These Grade B7 threaded rods meet the pressure and temperature requirements of ASTM A193 and are often used to secure pressure tanks, valves, and flanges.

Grade B16 threaded rods maintain their strength at higher temperatures than Grade B7 threaded rods. They meet the pressure and temperature requirements of ASTM A193 and are often used to secure pressure tanks, valves, and flanges.

Tighten these threaded rods by turning them to the left; once fastened, they resist loosening from counterclockwise motion. About half the strength of medium-strength steel threaded rods, use them for light duty hanging, mounting, and fastening.

Tighten these threaded rods by turning them to the left; once fastened, they resist loosening from counterclockwise motion.

Stronger and more wear resistant than 18-8 stainless steel, these threaded rods are mildly chemical resistant. They meet the pressure and temperature requirements of ASTM A193 and are often used to secure pressure tanks, valves, and flanges.

Tighten these threaded rods by turning them to the left; once fastened, they resist loosening from counterclockwise motion.

The most corrosion resistant stainless steel threaded rods we offer, these Alloy 20 stainless steel threaded rods contain nickel to withstand exposure to sulfuric, phosphoric, and nitric acids.

Unlike metal rods, these threaded rods will not warp at extreme temperatures, making them ideal for heat treating and furnace fixtures.

PTFE threaded rods withstand temperatures up to 250° F and resist oil, grease, detergents, and most mineral acids. They're the lowest friction plastic threaded rods we offer, so they thread on smoothly.

Brass threaded rods are corrosion resistant in wet environments, electrically conductive, and nonmagnetic.

Titanium threaded rods have a high strength-to-weight ratio and are resistant to acids and salt water.

Commonly used in valves, pumps, and shafts, these 400 nickel threaded rods resist salt water and caustic chemicals.

Screw these studs into a tapped hole and use them as a pivot point, hinge, shaft, or locator pin.

18-8 stainless steel studs have good chemical resistance.

18-8 stainless steel studs have good chemical resistance and may be mildly magnetic. Also known as hanger bolts, use them to hang, mount, and fasten parts to wood structures.

These studs have good chemical resistance. Weld them to stainless steel surfaces.

These steel studs are zinc plated to resist corrosion in wet environments.

A hollow center allows these studs to be used as an axle, a vent, or a passageway for wiring.

Connect float valve bodies and floats with these rods.

An easy-to-grip ball knob makes these handles a good replacement for gear levers. Use them to operate machinery.