Prevent waste from flying up as you work. A double blade makes two cuts to create a 7/64"-wide step that peels back, leaving little distortion and smooth edges.

Keep your hand away from the material being cut.

The handles are angled 90° from the blade so you can cut material from directly above tight spaces.

These cutters make straight cuts and curves.

Blades are tapered to give you more control when cutting straight lines, tight curves, and circles, and they're serrated to prevent slipping. These cutters are also known as duckbill snips.

Replace blades as they wear. These cutters are also known as tinners' snips.

Make round, square, and irregular-shaped holes with this punch-style hole cutter.

A double blade creates two cuts and a 7/32" wide waste strip that peels back, leaving two smooth edges with little distortion.

Also known as slotting shears, these cutters have a double blade that creates two cuts and a 7/32" wide waste strip that peels back, leaving two smooth edges with little distortion.

Make straight, clean cuts in thick sheet metal.

Combine the cutting base and a corner punch to make rounded corners in sheet metal.

Notch, cut, and pierce a variety of materials including metal, plastic, and vinyl.

Leave clean cut edges in a variety of pliable materials.

After each cut, the jaws spring open to make continuous cutting easy.

Insulated handles protect against shock from accidental contact with live electrical circuits. These scissors are tested to 1,000 volts to meet IEC 60900 and ASTM F1505.

Also known as electricians' shears, the back edge of the blade has a file to clean contacts.

Prevent snags and injury with the rounded points on these small scissors.

Trim flush against a flat surface with the curved blades on these small scissors.