Because the flanges are molded into the body for a wide sealing surface, these joints provide a tighter seal than other expansion joints. Each flange is supported by a zinc-plated steel plate. Flanges mate with a same-size flat-surface Class 150 flange without the need for a gasket. Joints reduce stress, vibration, and noise in metal piping systems by providing a point of flexibility to absorb movement. They have a flexible body that is reinforced with cord for added strength.

Mount these expansion joints as close as possible to anchor points.

The EPDM lining in these joints meets NSF/ANSI 61 standard for use with drinking water. To reduce stress, vibration, and noise in piping systems, they provide a point of flexibility to absorb movement. These joints have a flexible body reinforced with polyester plastic cord for added strength. A zinc-plated steel plate supports each flange. The flanges mate with the same-size flat-surface Class 150 flange without the need for a gasket.

Position the expansion joints as close as possible to anchor points.

These joints reduce stress, vibration, and noise in plastic piping systems by providing a point of flexibility to absorb movement. Joints provide a tighter seal than other expansion joints because the flanges are molded into the body for a wide sealing surface. Each flange is supported by a zinc-plated steel plate. Flanges mate with a same-size flat-surface Class 150 flange without the need for a gasket.

Position the expansion joints as close as possible to anchor points.

These joints are designed for vertical use to reduce stress, vibration, and noise in drain, waste, and vent systems. Slip them over the end of your pipe and tighten the band clamps for a secure hold. They have an internal stop to ensure pipe is in the proper position.

Connect male threaded pipe to these expansion joints to add a point of flexibility in your line that reduces stress, vibration, and noise. These joints have a double-bulb design that absorbs more movement and vibration than other expansion joints. Made of neoprene, they’re more abrasion resistant than silicone rubber joints. Their flexible body is reinforced with nylon for added strength.

Connect different pipe sizes in your line while adding a point of flexibility between them. These expansion joints absorb movement between two connected pipes to reduce stress, vibration, and noise. Their flanged ends mate with same-size Class 150 flanges without the need for a gasket. Each flange is supported by a zinc-plated steel plate. The body of these expansion joints is reinforced with cord for added strength.

Your pipe system must be rigidly anchored on both sides of the expansion joint to control expansion or contraction of the line. When proper anchoring cannot be provided, limit rods (sold separately) are required.