These bumpers absorb impact to protect equipment, walls, and floors from dents and scuffs. They're found everywhere from access panels to the bases of equipment. The rubber construction also stifles noise and absorbs vibration to prevent wear and tear to your machinery and nearby surfaces. No separate fasteners are needed—just twist them into a threaded hole.

Both bumper and plug, these protect equipment from impact while sealing off holes from dirt, dust, and water. They also grip surfaces, so they're often used as feet to keep instruments and bench-top equipment from sliding. No fasteners are needed—just push them into a hole for quick installation.

Unlike our other adhesive-back bumpers, these are tested to ensure they'll support the load of your application. Use them as feet on instruments and small appliances to limit sliding, vibration, and noise. The adhesive back forms a tight grip without scratching or discoloring your surface. They're comparable to Bumpon bumpers.

Both bumper and grommet, these protect equipment from impact while routing wire and other lines through a cushioned hole. All have stems that contract and expand for a snug fit. No fasteners are needed—just push them into a hole for quick installation.

Stick these bumpers onto glass and other surfaces that are too thin or fragile for fasteners. The adhesive back forms a tight grip without scratching or discoloring your surface. They're comparable to Bumpon bumpers.

Install these with your own screw anywhere you need a bumper. In addition to protecting equipment and surfaces from dents and scuffs, they absorb vibration to reduce noise and wear on machinery.