Fit these relays where standard spade-terminal relays are too big.

Isolate input and output circuits to prevent damage from voltage spikes, reduce signal interference, and amplify signal.

Smaller than relays with electrical wiring, these relays fit in compact devices. Mount them through holes on circuit boards with their solder pin terminals.

These relays handle the high starting (inrush) currents that often occur when turning on a vehicle.

Sealed to keep out water, these relays are often used for DC-powered equipment such as forklifts, floor scrubbers, and trucks.

Sealed for safety, these relays are a good choice for hazardous locations where combustible or corrosive gases may be present.

Send a signal to turn equipment on and off from up to 150 feet away without having to run electrical wire. These relays have an enclosure to protect the terminals from dust and accidental bumps.

Also known as an air-to-electric switch, this relay converts an air signal to an electric signal.

Prevent changes in frequency from damaging sensitive equipment.

Protect electrical equipment from overcurrent and undercurrent damage—these relays continuously monitor current flow.

Attach these relays to a flat surface using the mounting hole. They have no moving parts, so compared to mechanical switches, they require less maintenance, last longer, and are quieter.

Install these relays in a panel cutout or plug them into a relay socket. Unlike mechanical relays, these solid state relays have no moving parts, so they require less maintenance and last longer, are quieter, and switch faster.

Whether installed in an electrical cabinet or hard-to-reach area, these timer relays are controlled remotely from your smartphone. They connect to your phone via a free downloadable app so you can set time delay ranges, adjust settings, and save programs.

Mount these monitors to DIN rail.