Suitable for use in washdown applications, these plastic collars also offer good chemical resistance.

With larger screws than those found on standard clamping collars, these provide a stronger grip on your shaft without using additional screws.

Wider than standard shaft collars with twice the number of clamping screws, these ensure a better grip for greater holding power.

Although these collars fit inch-sized shafts, they have a metric OD and width for use with metric equipment.

Suitable for use in washdown applications, these plastic collars also offer good chemical resistance.

With larger clamping screws than those found on standard clamping collars, these provide a stronger grip on your shaft without using additional screws.

Wider than standard shaft collars with twice the number of clamping screws, these ensure a better grip for greater holding power.

Internal ball bearings allow you to slide a collar onto your shaft in one direction and then automatically lock the collar in place in the opposite direction.

An embedded sleeve squeezes the shaft as you tighten the clamping screws, allowing these collars to handle up to three times the thrust load of standard collars.

One side of these collars locks down like a standard one-piece shaft collar; the other has a flush face that's flat to 0.0005", which lets you mount the collars on a shaft next to precision bearings, sprockets, and gears.

Secure items to either side of these collars—each half has a flat end with a tapped hole

Three tapped counterbored holes and three through-holes provide mounting flexibility.

These collars have two different sides—one locks down like a standard clamping shaft collar; the other has a flush face that you can machine to add slots, holes, and grooves to match your special setups.

To install, slide these one-piece collars onto the end of your shaft.

Slide these one-piece collars onto the end of your shaft to create an end-stop for linear components.

Install these collars anywhere on a shaft without removing components or having access to the ends of the shaft.

To install, slide these one-piece collars onto the end of your shaft.

Install these collars anywhere on a shaft without removing components or having access to the ends of the shaft.

Mount these hangers on top of one another to organize multiple lines of pipe, tubing, and conduit at any angle.

These plastic hangers prevent corrosion caused by metal-to-metal contact. Push them closed for a more secure hold on material than loop hangers.

Secure two pressurized hydraulic lines with a single clamp to lessen vibration in hydraulic systems. Weld the bottom plate onto the mounting surface for a more secure connection than rail- and adhesive-mount clamps.

Slide multiple clamps into existing strut channel to organize lines of pipe, tubing, and conduit without the need for drilling, welding, or using adhesive. Clamps have a plastic or rubber cushion or body to reduce vibration.

Secure two pressurized hydraulic lines with a single clamp. Mount these clamps directly onto rails, no adhesive or welding required. They fit tightly around the lines to reduce vibration.

Route pipe, tubing, and conduit across strut channel.

Sized to fit snugly around pipe, these collars are often used to support pipe passing through floors and walls.

Sized to fit snugly around pipe, these collars have flats so you can turn the collar and your pipe using a standard wrench.

Mount these two-piece collars anywhere on an Acme lead screw without removing components.