The spring-loaded bolt stays latched until you pull it back—slide the bolt and drop the knob into the notch to secure. These latches are reversible for right- and left-hand mounting.

Tug the spring-loaded handle to disconnect doors. The pin in these hinges retracts to unhook the door and then snaps back when released. They come in pairs, one left-side and one right-side hinge.

The spring-loaded bolt stays latched until you pull it back. These padlockable latches are reversible for right- and left-hand mounting.

These hangers are a popular choice for overhead applications. The spring holds the washer and toggle against opposite sides of the wall, so everything's in position before you begin tightening. To install, insert the bolt through your fixture and thread the toggle onto it. Next, fold the toggle wings flush against the bolt and push them through a drilled hole until they pop open on the other side. Once tightened, the spring adds vibration resistance. Zinc yellow-chromate plating provides corrosion resistance in wet environments. Dimensions meet ASME B18.6.3 specifications.

Mount these latches on a corner to draw perpendicular surfaces together. Designed with compression springs to withstand vibration better than standard draw latches, they offer a more secure hold. The overall length listed includes the strike plate.

Mount this latch on a corner to draw perpendicular surfaces together. It has a safety catch to prevent accidental opening. Designed with compression springs to withstand vibration better than standard padlockable draw latches, it offers a more secure hold. The overall length listed includes the strike plate.

Pinch the handles together to disconnect doors. The pin on these hinges retracts to unhook the door and then snaps back when released. Both a hinge and a latch, they're commonly used on cabinet lids, electrical enclosure doors, and computer equipment housings. To swing doors in either direction, use four hinges. Install two on each side to act as either pivot points or release latches.

Keep a variety of toggle bolt anchor sizes and lengths on hand. These classic toggle anchors are best for securing handrails, cabinets, and shelving in drywall. All have a spring-loaded toggle that firmly grips behind your wall. Since the gripping force is spread over the length of the toggle, they create a stronger hold than plug anchors. However, they require a larger hole to push the toggle through, which may need patching if not covered by your component.

To install, insert the bolt through your component and thread on the toggle. Then, fold the toggle wings flush against the bolt and push them through a drilled hole until they pop open on the other side. Next, pull back on the bolt and tighten it for a secure hold. The bolt is reusable, but the toggle will fall behind the wall when the bolt is removed.

Commonly used to install standoffs to mount signs or panels, these anchors create threaded-stud connections that stay put. All have a spring-loaded toggle that firmly grips behind your wall for a secure hold. Since the gripping force is spread over the length of the toggle, they create a stronger hold than plug anchors. However, they require a larger hole to push the toggle through, which may need patching if not covered by your component.

To install, insert the stud through your component and thread on the toggle. Then, fold the toggle wings flush against the stud and push them through a drilled hole until they pop open on the other side. Next, pull back on the stud and thread on a nut to secure. The stud is reusable, but the toggle will fall behind the wall when the stud is removed.

These classic toggle anchors are best for securing handrails, cabinets, and shelving in drywall. All have a spring-loaded toggle that firmly grips behind your wall. Since the gripping force is spread over the length of the toggle, they create a stronger hold than plug anchors. However, they require a larger hole to push the toggle through, which may need patching if not covered by your component.

To install, insert the bolt through your component and thread on the toggle. Then, fold the toggle wings flush against the bolt and push them through a drilled hole until they pop open on the other side. Next, pull back on the bolt and tighten it for a secure hold. The bolt is reusable, but the toggle will fall behind the wall when the bolt is removed.