McMaster-Carr logo
    Forward
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Print
    How can we improve?
    Comments
    E-mail address (if you would like a response)
    6 Products

    Sprockets

    Image of Product. Plain Bore. Front orientation. Drive Sprockets. Sprockets, For Single Strand, Plain Bore.

    Plain Bore

    Sprocket teeth mesh with your roller chain to smoothly transmit power. These U.S.-made sprockets have machined teeth for a more precise fit than flame-cut or punched teeth, allowing them to glide in and out of the chain to reduce wear and extend chain life.
    Steel—Steel is strong, but best for dry environments since moisture will cause it to rust.
    Plain Bore—Plain bore sprockets give you options—machine a custom bore, weld, or press-fit them in place. They're sized to the minimum shaft diameter listed and are machinable up to the maximum.
    For
    Roller Chain
    Trade
    No.
    Std.
    Pitch,
    mm
    No. of
    Teeth
    OD,
    mm
    Bore
    Type
    For Shaft
    Dia.
    Each
    For Single Strand
     
    Steel
    04BISO6818Plain5 mm to 7 mm2302K67000000
    04BISO6920Plain5 mm to 7 mm2302K6800000
     

    GT Timing Belt Idler Pulleys

    Image of Product. Front orientation. Timing Belt Idler Pulleys. GT Timing Belt Idler Pulleys, Toothed.

    Toothed

    Image of Attribute. Front orientation. Contains Annotated, Border. GT Timing Belt Idler Pulleys.
    Get pitch-perfect compatibility with these free-spinning pulleys. They mesh with belts that have curved GT-profile teeth, reducing vibration and wear. As they rotate on their bearings, these pulleys press up against belts to reduce slack and keep the system moving smoothly. All are compatible with GatesPowerGrip GT, 2GT, GT2, GT3, and GT4 series. Idler pulleys are often used with belt tensioners.
    Corrosion-Resistant Aluminum—Lightweight and resist rust in wet environments. Although aluminum pulleys are one-third the weight of iron pulleys, they aren't as strong.
    Toothed
    For Max.
    Belt Wd., mm
    Pitch,
    mm
    For Shaft
    Dia., mm
    OD,
    mm
    Bearing
    Type
    No. of
    Teeth
    Each
    For 2MGT Trade Size
     
    Corrosion-Resistant Aluminum
    62515Ball
    		203693N1100000
    92515Ball
    		203693N120000
    122515Ball
    		203693N130000
     

    Quick-Grip Screw-Clamp Bushings

    Image of Product. Front orientation. Pulley and Sprocket Bushings. Quick-Grip Screw-Clamp Bushings.
    Also known as Trantorque bushings, these tighten with a twist of the collar nut—no screws needed. As you tighten the collar nut, the inner sleeve contracts onto the shaft and the outer sleeve expands to hold your sprocket, pulley, or gear.
    For Shaft
    Dia., mm
    OD,
    mm
    Overall
    Wd., mm
    Max. Torque,
    in·lbf
    Each
    Steel
    516191502298K1000000
     
    back to top