McMaster-Carr logo
    Filter by
    Component
    Number of Teeth
    System of Measurement
    Face Width
    Attribute Image
    OD
    Attribute Image
    Gear Pitch
    Industrial Info Snippet
    Gear Type
    Shaft Diameter
    Attribute Image
    Bore Type
    Gear Pitch Diameter
    Industrial Info Snippet
    Attribute Image
    Material
    Pressure Angle
    Hub Width
    Attribute Image
    Overall Width
    Attribute Image
    Hub Diameter
    Attribute Image
    U.S.–Mexico–Canada Agreement (USMCA) Qualifying
    Width
    Color
    DFARS Specialty Metals
    Export Control Classification Number (ECCN)
    Industrial Info Snippet
    Fabrication
    Forward
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Print
    How can we improve?
    Comments
    E-mail address (if you would like a response)
    3 Products

    Plastic Spur Gears

    Made of plastic, these spur gears run more quietly than metal gears and have good corrosion and chemical resistance. However, they’re not as strong as metal gears, so they’re best for light duty applications. Combine a gear and rack to convert rotary motion into linear motion.
    Combine gears with different numbers of teeth to change speed and torque in your assembly. For components to mesh correctly, they must have the same pressure angle and pitch/module.
    Gears
    Image of Product. Front orientation. Spur Gears. Plastic Spur Gears, 14 1/2° Pressure Angle, Round Bore.

    14 1/2° Pressure

    Angle, Round Bore

    14 1/2° Pressure Angle—A former industry standard, 14½° pressure angle gears are often found in older machinery.
    Nylon—Nylon gears are wear resistant, but will swell and weaken over time when wet.
    Hub
    Gear
    Pitch
    No. of
    Teeth
    Gear Pitch
    Dia.
    OD
    Face
    Wd.
    Dia.
    Wd.
    Bore Type
    For Shaft
    Dia.
    Color
    Each
    14 1/2° Pressure Angle
     
    Nylon
    16
    		301 7/8"2"7/8"1.625"0.5"Round Bore63/64"White57655K57000000
     
    Gear Racks
    Image of Product. Front orientation. Spur Gear Racks. Plastic Spur Gears, 14 1/2° Pressure Angle—Rectangular.

    14 1/2° Pressure

    Angle—Rectangular

    These racks match with spur gears to convert rotary motion to linear motion. For components to mesh correctly, they must have the same pressure angle and pitch/module.
    Nylon—Nylon gear racks are wear resistant, but will swell and weaken over time when wet.
    Machined—Machined gear racks may be slightly bowed but will straighten out when installed.
    Gear
    Pitch
    Lg.,
    ft.
    Pitch
    Ht.
    Ht.
    Face
    Wd.
    Fabrication
    Color
    Each
    14 1/2° Pressure Angle—Rectangular
     
    Nylon
    16
    		10.25"5/16"5/16"MoldedWhite57655K64000000
    16
    		40.438"1/2"1/2"MachinedGreen60435K89000000
     
    back to top