A quick push is all it takes to actuate these switches.

Sized for 4 mm or 6 mm panel cutouts, these switches are often used with circuit boards to control electronics.

More durable than standard metal switches, these can handle tough, repetitive use.

The face of these switches mounts flush against a panel, so they're easy to clean and hard to damage.

Save space on a panel by using one switch to perform multiple switching functions.

Immediately cut power with a single push.

Rated NEMA 4X and 13, all switches resist corrosion and can withstand washdowns and oil/coolant spraying.

Rated NEMA 3S, NEMA 4X, NEMA 13, and IP66, these plastic switches resist corrosion better than aluminum switches and withstand washdowns and oil/coolant spraying.

Mount these switches in an outlet box. Also known as palm-button switches, they have a large button that makes them easy to use even while wearing gloves.

Grip and twist a lever to turn these switches on or off—they’re designed to prevent accidental actuation. Install them into standard-sized panel cutouts.

Choose an actuator and contact block to make your own 22 mm plastic switch.

Choose an actuator and contact block to make your own 22 mm metal switch.

Control cranes and other mobile machinery in dirty, outdoor, and wet environments without damaging your switch.

Designed for use near ignitable gases, fibers, and dust, these switches have a housing that seals in anything that could ignite flammable material. They require a key to turn circuits on or off, preventing accidental activation and limiting access.

Intuitively steer and position cranes, robot arms, and other machinery that moves in multiple directions—your equipment will follow the movements you make with these joysticks.

At least 25% smaller than our Miniature Snap-Acting Switches, these switches are often used to trigger actions from inside a vehicle’s door or an engine compartment.

Sealed actuators prevent these switches from jamming, even when exposed to oil, sand, mud, or ice.

Prevent unauthorized use—these switches require coded magnets to actuate. They cannot be bypassed using ordinary magnets.

Since these switches don’t have a housing above the probe, they are often used in tight spaces and low-clearance areas.

Mount these switches through an unthreaded hole in your tank wall and secure with a nut from outside the tank.

Empty and fill your tank with a single device—these dual-level switches include two float switches that actuate at different levels. Mount through a threaded connection at the top of your tank.

For visual monitoring and easy access, these switches are housed in a clear acrylic reservoir that mounts to the outside of your tank.

Mount these switches from outside the tank through a threaded connection at the top or bottom of your tank.

Hang these free-floating switches in your tank for liquid-level monitoring that doesn't require installation through a tank wall.

Mount these switches through an unthreaded hole in your tank wall and secure with a nut from outside the tank.

Designed for use in areas where flammable substances are present, these switches are CSA certified for hazardous locations.

Detect chemical level with infrared light to avoid false switch activation caused by vibration in your tank.

Install these switches into an unthreaded hole at the top or bottom of your tank and secure with a nut from inside the tank.

Mount these switches into a threaded connection at the top or bottom of your tank.

Mount these switches through an unthreaded hole in your tank wall and secure with a nut from inside the tank.

A polypropylene float makes these switches buoyant even in viscous liquids.