About half the strength of medium-strength steel coupling nuts, these nuts are for light duty fastening applications.

The left-hand threads on these coupling nuts resists loosening from counterclockwise vibration. Use in light duty applications.

Choose these locknuts to fasten standard metric threads. They’re Class 8 steel, so they can be used in most fastening applications.

These metric-sized coupling nuts are Class 10 steel, so they’re about 25% stronger than medium-strength steel coupling nuts.

These coupling nuts have good chemical resistance.

More corrosion resistant than 18-8 stainless steel coupling nuts, these nuts have excellent resistance to chemicals and salt water.

Known for their strength, steel coupling nuts are available with a corrosion-resistant finish.

A smooth rounded body provides a finished look.

Position components in assemblies, as well as separate or connect parts with these standoffs.

These standoffs are made to NAS specifications.

Mount components onto food processing lines, walls, and sanitary equipment while leaving space to clean in between.

A nickel-chrome plating gives these standoffs a mirror-like finish.

A recess under the hex clinches a panel for a strong hold that won't push, pull, or twist out. When mounted with a lever press, the hex sits flush with the surface and the open end creates a through hole.

Also known as captive standoffs, a recess under the hex clinches the panel for a strong hold that won't push, pull, or twist out. When mounted, the hex sits flush with the surface and the closed end creates a neat, finished appearance.

Once the end is clinched in place, panels with keyholes easily slide on and off these supports.

Connect two differently sized male-threaded parts, such as threaded rods, and tighten with a standard wrench.

Increase or decrease metric thread size from one male-threaded part to another. Commonly used to connect two differently sized threaded rods, they have a hex-shaped body, so you can tighten them with a standard wrench.

Change thread sizes or types, such as fine to coarse threads, on parts without changing gender.

Change inch threads to metric with these adapters, or swap metric threads for inch. An external hex lets you tighten or loosen them with a wrench.

Connect male- and female-threaded parts of different thread types and sizes, while allowing air, liquids, wire, or other thin materials to pass through.

Twist these adapters onto female metric threads to change pitch or switch thread sizes.

Similar to turnbuckles, these rods have right-hand threads on one end and left-hand threads on the other so you can make a linkage that adjusts for tension.

Designed for use with right-hand, externally threaded rod ends, these rods have right-hand threads on both ends. Use them for remote valve operators, throttle controllers, shifting mechanisms, and virtually any push/pull assembly.

Attach these nuts to rods, pipes, and tubes to make pivoting and hinge movements where misalignment is not a concern.

Use these nuts with a sleeve and fitting to provide a tight metal-to-metal seal on steel tubing that is flared to 37°.

Use these nuts with compression sleeves and fittings, also known as bite fittings, to create a strong seal on steel tubing.

These nuts attach to high-pressure nipples for compressed gas so you can connect your tank to the inlet of a pressure regulator.

Use these fittings in extreme-pressure conditions up to 15,000 psi.

The strongest steel fittings we offer, these can withstand extreme-pressure applications.