Mount these switches in panel cutouts where changing a battery or routing wires might be difficult—they power themselves when you push the button.

A base that lights up draws attention to emergency stops. When pushed, these switches immediately cut power.

A protective plastic enclosure resists dents, chips, and cracks, so you can install these switches outside of panels.

Choose an actuator and contact block to make your own 22 mm plastic switch.

The light touch of a finger turns circuits on and off without pressing down a contact. Program these switches to fit your application—control their color, pattern, and sensitivity.

The convenient, modern alternative to mechanical safety switches. These RFID switches are easier to install, fit a wider range of access points, and can mount horizontally.

Prevent accidental bumps or vibration from triggering these safety switches unnecessarily—a strong magnet maintains the RFID signal between the actuator and switch until it's intentionally opened.

Twist the sensor to detect metallic objects where explosive dust or gas may be present—the sensor rotates for front, side, top, or bottom sensing. These switches are UL and C-UL listed as well as ATEX and IECEx certified for hazardous locations.

Sense objects from farther away than with other DC proximity switches that have the same diameter.

These switches have a longer sensing distance compared to other proximity switches with the same diameter.

Rated IP69K, these switches can withstand high-pressure, high-temperature washdowns and temporary submersion.

Often used with programmable logic controllers (PLCs), these switches use DC input voltage and produce PNP or NPN signal output.

These switches actuate when a magnet comes within sensing distance, and reset when the magnet moves away.

Install these switches in areas with oil, coolant, corrosive chemicals, and regular washdowns. They're rated IP69K and NEMA 4X and 12 or 12K.

From factory floors to railway systems, the sturdy connections on these switches connect cabled devices in tough environments.

Measure the level of conductive liquids without drilling a hole in your tank—these switches mount to the outside of the tank and track the capacitance between them and the tank’s contents.

Easy to clean and install, these flow switches are 3-A certified to meet sanitary design standards and insert into your line with a quick-clamp mounting adapter. They send digital signals to your programmable logic controller (PLC) to activate automated controls or alarms when they reach a set flow rate.