Simple to use, these switches actuate with a quick push.

A housing seals in anything that could ignite flammable material, so you can use these switches where explosive gas, dust, and fibers may be. They actuate with a quick push.

Push the button to actuate these switches. Colored actuators help you tell switches apart without reading labels.

Actuate these switches with the push of a button. Their buttons are distinct colors to help you quickly spot switches without labels.

Actuate these switches with a quick push. A housing seals in anything that could ignite flammable material, so you can use them where ignitable gas and dust may be present.

Immediately cut power with a single push.

Immediately cut power with a single push.

A protective plastic enclosure resists dents, chips, and cracks, so you can install these switches outside of panels.

Made of yellow polycarbonate plastic, these enclosed switches are easy to see and resist dents, chips, and cracks. They are more corrosion resistant than aluminum enclosed switches and withstand washdowns and oil/coolant spraying.

Mount these switches in an outlet box. Also known as palm-button switches, they have a large button that makes them easy to use even while wearing gloves.

Grip and twist a lever to turn these switches on or off—they’re designed to prevent accidental actuation. Install them into standard-sized panel cutouts.

The wide surface of these switches makes them easy to press on and off, even if your hands are full and you need to use an elbow.

Choose an actuator and contact block to make your own 30 mm switch.

Choose an actuator and contact block to make your own 22 mm metal switch.

Operate equipment from up to 330 feet away—these switches include a transmitter and a receiver that connects to equipment.

Designed for use near ignitable gases, fibers, and dust, these switches have a housing that seals in anything that could ignite flammable material. They require a key to turn circuits on or off, preventing accidental activation and limiting access.

Open and close circuits in a snap. These switches actuate quickly to minimize arcing and prevent contacts from sticking.

At least 25% smaller than our Miniature Snap-Acting Switches, these switches are often used to trigger actions from inside a vehicle’s door or an engine compartment.

Our most sensitive limit switches, these switches actuate with the slightest push for a high degree of accuracy.

These switches actuate when a magnet comes within sensing distance, and reset when the magnet moves away.

Set to actuate at a specific temperature, these switches are easy to setup and prevent changes to the setpoint. They have a threaded probe, so they install directly into tanks, pipelines, and other process components to turn equipment on and off at a set temperature.

Install these switches into a threaded connection in your tank wall from outside the tank.

Mount these switches from outside the tank through a threaded connection.

Use the included bracket to mount these switches to the inside of your tank.

Empty and fill your tank with a single device—this dual-level switch includes two float switches that actuate at different levels. Mount through a threaded connection at the top of your tank.

Install these switches into an unthreaded hole at the top or bottom of your tank and secure with a nut from inside the tank.

Install these switches into a threaded connection in your tank wall from outside the tank.

Detect water level with infrared light to avoid false switch activation caused by vibration in your tank.

This switch mounts to the outside of your tank and detects chemical level through plastic tank walls by measuring the capacitance between the switch and tank contents; it cannot be used with metal tanks.

Mount these switches from outside the tank through a threaded connection at the top or bottom of your tank.

Use the included bracket to mount these switches to the inside of your tank.

Mount these switches through an unthreaded hole in your tank wall and secure with a nut from inside the tank.

Mount these switches into a threaded connection at the top or bottom of your tank.