Prevent accidental activation and limit access—these switches require a key to turn circuits on or off. All fit into a standard panel cutout.

Operate low-voltage devices that require less than 48 volts, such as doorbells and buzzers. These switches have one input terminal and three output terminals to control up to three devices at once.

Rated NEMA 4 or IP66, these switches are protected from washdowns. They require a key to turn circuits on or off, limiting access to sensitive equipment. All fit into a standard panel cutout.

Brighten or dim your facility or workstation's light from a control panel. These dimmers fit through a standard panel cutout. Lightly press and hold your finger to adjust the light level. Rated IP67, these dimmers are so watertight they could even handle brief submersion. They also seal out dust.

Dimmers are great if you want to control the brightness from one place but turn the light on or off from a switch somewhere else. For example, you might want to dim a light over your storage area from a main control panel for energy efficiency but still be able to turn it on or off when you enter the area.

With a round key that is difficult to duplicate, these switches provide a higher degree of security than standard key switches.

These valves close all ports in the off position to stop equipment in a locked position with air pressure holding it in place. Often used to extend and then retract a cylinder at different speeds, they create two actions and have two exhaust ports, which allows you to control the speed of each action by attaching a flow control valve to each exhaust port. They direct airflow from the inlet to your equipment and exhaust return airflow to create motion. Also known as 4-way and 5/3 closed center valves.

Also known as 4-way and 5/3 pressure center valves, these valves create two actions at the same time, such as extending two single-acting cylinders at once. They direct airflow from the inlet to your equipment and exhaust return airflow to create motion.

In the off position, these valves exhaust all air pressure, allowing the equipment to return to the neutral position. Often used to extend and then retract a cylinder at different speeds, they create two actions and have two exhaust ports, which allows you to control the speed of each action by attaching a flow control valve to each exhaust port. They direct airflow from the inlet to your equipment and exhaust return airflow to create motion. Valves without an exhaust connection exhaust air to the atmosphere. Also known as 4-way and 5/3 exhaust center valves.

Often used to extend and then retract a cylinder at different speeds, these valves create two actions and have two exhaust ports. They direct airflow from the inlet to your equipment and exhaust return airflow to create motion. Also known as 4-way and 5/2 valves.

Pair these cables with a knob or lever (not included) to operate valves, throttle controls, and HVAC damper controls from a distance. They're flexible for weaving around obstructions.