We will reply to your message within an hour.
These switches meet MIL-S-3950.
Built into a terminal block, these switches mount to DIN rail.
A built-in relay produces AC voltage output. These switches are often used with older programmable logic controllers (PLCs).
Set these switches to delay activation by up to five seconds after detecting an object.
Control equipment with high currents, such as landscape lighting, pumps, and heaters.
Rated NEMA 3R, these rain-tight switches protect against falling liquids and light splashing.
Switches fit single device (1 gang) outlet boxes.
For precise control of high-current equipment such as landscape lighting, pumps, and heaters, these switches schedule on/off times to the exact minute.
Regulate line-voltage HVAC systems.
A built-in guard prevents accidental changes and other tampering and protects these thermostats from damage. These thermostats regulate the temperature in HVAC systems that use direct electrical power.
Set these thermostats to adjust the temperature at certain times each day. They regulate heaters that use direct electrical power, such as baseboard and wall heaters.
Plug in the thermostat, then plug your heater into the socket on the thermostat's plug.
Regulate temperatures in washdown areas for HVAC systems that use direct electrical power, such as air conditioners and heaters.
Also known as snap discs, these thermostats switch on cooling systems or switch off heating systems when equipment gets too hot.
Keep electronics in your enclosure from getting too hot or cold with these thermostats that control two devices at once.
Control a single heating or cooling device in your enclosure to keep electronics at a safe operating temperature.
Factory set to activate equipment when your drinking water system reaches a fixed level, these flow switches are easier to install than adjustable flow switches.
Since they come factory set to a specific set point, these switches are easier to install than adjustable flow switches.
Quicker to install than adjustable flow switches in high-pressure lines, these switches come factory-set to activate or deactivate equipment at a specific level. They compensate for the viscosity and density changes of liquid.
When these switches reach a set flow rate, they send digital signals to your programmable logic controller (PLC) to activate automated controls or alarms.
Easy to clean and install, these flow switches are 3-A certified to meet sanitary design standards and insert into your line with a quick-clamp mounting adapter. They send digital signals to your programmable logic controller (PLC) to activate automated controls or alarms when they reach a set flow rate.
Instead of disassembling your system for inline installation, thread these flow switches onto a mounting adapter and insert them into a pipe tee or pipe outlet. They send digital signals to your programmable logic controller (PLC) to activate automated controls or alarms when they reach a set flow rate.