Twist the sensor to detect metallic objects where explosive dust or gas may be present—the sensor rotates for front, side, top, or bottom sensing. These switches are UL and C-UL listed as well as ATEX and IECEx certified for hazardous locations.

The flexible cable on these switches withstands applications that require frequent motion, such as robotics.

Eliminate the need to calculate the sensing distance when using different metals—these switches sense all metal at the same distance. Also known as K=1 sensors.

Sense objects from farther away than with other DC proximity switches that have the same diameter.

These inductive proximity switches sense metallic objects each time they pass through the slot, even when they’re obscured by water, oil, dirt, or a surface finish. Use them to measure the speed of rotating equipment and to count or detect moving objects, such as sheet metal being fed into a stamping process.

Turn the face on these switches to sense metallic objects from the front, sides, top, or bottom.

Mount these intrinsically safe switches to flat surfaces in volatile areas. Their low-current, low-voltage NAMUR signal means they won’t ignite or create sparks while in use. ATEX and IECEx certified, they meet international standards to protect against explosion where combustible dust and flammable gases are present.

About half the length of our other flat-body proximity switches, these switches fit in crowded spaces and along rails.

Check the position of your torch or workpiece for accuracy during robotic welding.

Switches accept both AC and DC input voltage.

These switches have a longer sensing distance compared to other proximity switches with the same diameter.

Mount these flat inductive switches to a base or rail to remotely detect metallic objects in wet and dirty environments.

A built-in relay produces AC voltage output. These switches are often used with older programmable logic controllers (PLCs).

Light beams travel up to 32 ft. between the transmitter and receiver.

With a narrow, flat body, these switches fit in tight spaces.

Set these switches to delay activation by up to fifteen seconds after detecting an object.

About half the size of most standard photoelectric switches, these fit comfortably in tight spaces. The transmitter and receiver are built into the housing, so you don’t need to align components or measure sensing distance to install them.

Detect objects as thin as a freshly sharpened pencil tip. These switches are best for tight spaces because they have a smaller light beam and can detect smaller objects than standard photoelectric switches.

Detect irregularly shaped items with a band of light up to 10 times larger than the beam on a standard photoelectric switch.

Maintain sanitary standards—these switches have smooth surfaces without crevices, so they prevent bacteria from building up and are easy to clean.

Easily mount these flat switches to a base or rail.

These switches use a NAMUR signal to operate at a low current and voltage, so they won’t ignite or produce sparks. ATEX certified, they protect against explosion in environments containing flammable gases and combustible dust. Switches sense both metallic and nonmetallic objects.

These switches detect magnetic objects—or objects with a magnet attached—through non-magnetic walls.

Support flow and temperature control in your system with these intrinsically safe switches, which sense when a valve is open or closed in volatile areas. They are ATEX and IECEx certified to protect against explosion.

Wire contacts to an alarm system to alert when doors or windows are opened.

Use a free, downloadable app with these switches to automate alarms in your facility, such as sounding a buzzer if a trailer door is opened after a certain time.

Prevent unauthorized use—these switches require coded magnets to actuate. They cannot be bypassed using ordinary magnets.