Simple to use, these switches actuate with a quick push.

A housing seals in anything that could ignite flammable material, so you can use these switches where explosive gas, dust, and fibers may be. They actuate with a quick push.

Push the button to actuate these switches. Colored actuators help you tell switches apart without reading labels.

Actuate these switches with the push of a button. Their buttons are distinct colors to help you quickly spot switches without labels.

Actuate these switches with a quick push. A housing seals in anything that could ignite flammable material, so you can use them where ignitable gas and dust may be present.

Immediately cut power with a single push.

Sized for 4 mm or 6 mm panel cutouts, these switches are often used with circuit boards to control electronics.

Install in 12 mm dia. cutouts.

A protective plastic enclosure resists dents, chips, and cracks, so you can install these switches outside of panels.

Made of yellow polycarbonate plastic, these enclosed switches are easy to see and resist dents, chips, and cracks. They are more corrosion resistant than aluminum enclosed switches and withstand washdowns and oil/coolant spraying.

Mount these switches in an outlet box. Also known as palm-button switches, they have a large button that makes them easy to use even while wearing gloves.

These switches are protected from corrosion, high-temperature and high-pressure washdowns, and oil/coolant spraying. Install them in 22 mm dia. cutouts.

Rated NEMA 4, 13, and IP66, these metal switches are protected from washdowns and oil/coolant spraying. Install them in 30 mm dia. cutouts.

Made for areas where ignitable gas and vapor may be present, these switches have a housing that seals in anything that could spark flammable material.

The enclosure not only protects these switches, but also adds options for how you install them.

Make or break an electrical circuit. These contact blocks mount to manual switches and transmit an electrical signal when the switch actuator is engaged.

Choose an actuator and contact block to make your own 22 mm plastic switch.

Choose an actuator and contact block to make your own 16 mm switch.

Install these key switches in 3/4" dia. panel cutouts. They require a key to turn circuits on or off, limiting access to sensitive equipment.

Install these key switches in 30 mm dia. panel cutouts. They require a key to turn circuits on or off, limiting access to sensitive equipment.

These 16 mm switches require a key to turn circuits on or off, limiting access to sensitive equipment.

Turn these switches by hand.

Immediately cut power by pulling the cable.

Connect these switches to a cable to control circuits from a distance. They're typically used to turn off production lines and material handling systems.

When a moving object contacts the actuator on these switches, they open or close a circuit. They have the rapid-closing action of a snap-acting switch, but with a larger actuator for large objects.

Quickly and safely mount these relays on 35 mm DIN rail (also known as DIN 3). IP20 rated, they have recessed terminals that prevent fingers and other objects from touching live circuits.

Isolate input and output circuits to prevent damage from voltage spikes, reduce signal interference, and amplify signal.

Sealed for safety, these relays are a good choice for hazardous locations where combustible or corrosive gases may be present.

Reduce connection errors on circuit boards that control machine guards and other safety devices. These relays take up less space on a board than those with electrical wiring because their solder pin terminals mount directly through circuit board holes.