Because these switches mount flush against a panel, they're easy to clean and hard to damage.

Install in 10 mm dia. cutouts.

Made of yellow polycarbonate plastic, these enclosed switches are easy to see and resist dents, chips, and cracks. They are more corrosion resistant than aluminum enclosed switches and withstand washdowns and oil/coolant spraying.

Operate equipment from up to 330 feet away—these switches include a transmitter and a receiver that connects to equipment.

Keep your hands free for other tasks by triggering switches with your foot.

Operate these switches hands-free when working in damp or humid environments.

Step on these switches for hands-free actuation in an area with frequent washdowns.

These switches are rated for environments where hazardous material is present.

Reset fire panels, or open electromagnetic locks, electric strikes, and automatic door openers. These switches require a key to turn circuits on or off, limiting access and preventing accidental activation.

It takes two hands to activate these switches, minimizing the risk of accidental equipment start up.

Rated NEMA 4 , these enclosed switches have a sealed actuator for protection from washdowns.

Keep out dirt and moisture—the sealed housing on these switches is watertight and meets MIL-PRF-8805.

Built for tight spaces exposed to water, these switches have a housing that's less than 1" long and IP67 rated for protection from temporary submersion.

Actuate these switches with a fraction of the force of other subminiature switches for increased responsiveness. Among the smallest snap-acting switches we offer, they fit into the tiniest of spaces.

Smaller than standard snap-acting switches, these switches trigger actions in tight spaces. They’re used in components as small as computer mice and engine restart switches.

Start or stop equipment after a set number of rotations to avoid over-rotation.

A sealed actuator prevents these switches from jamming, even when exposed to sand, mud, or dirt. With a slim design, you can stack them together or fit them in tight spaces.

Set these switches to delay activation by up to five seconds after detecting an object.

The highly flexible fiber-optic cable and small sensing end help you position these switches in hard to reach areas.

Install these switches in a panel cutout to automatically turn electrical equipment on or off after a set interval.

Install these switches in a panel cutout.

Mount these switches to a flat surface or attach to DIN rail.