Position two strut channels at a 30° to 60° angle, then tighten the bolt to secure.

Zinc-plated steel pivots are more corrosion resistant in wet environments than powder-coated steel.

Galvanized steel pivots have better corrosion resistance in wet environments than zinc-plated steel and can be used outdoors.

304 stainless steel pivots are more corrosion resistant than galvanized steel. They also have good chemical resistance.

For technical drawings and 3-D models, click on a part number.

To reinforce loose or damaged hinges, mount one of these hinges to the top edge of the pull-side of the door. They are for doors that swing in one direction and are flush with the frame or have up to a 1/8" offset. All hinges have a nonremovable pin to deter tampering. To choose a door mounting location, stand on the push side of the door—use a right-side hinge if the hinge is on the right or a left-side hinge if it’s on the left.

For technical drawings and 3-D models, click on a part number.

One leaf mounts around the edge of the door for a secure hold, while the other mounts to the frame. Longer than other entry door hinges, this piano-style hinge runs the entire length of doors for strength and durability. Bearings allow the hinge to open and close doors smoothly. A nonremovable pin deters tampering. Capacity is based on a maximum door size of 4' Wd. × 7' Ht. Cut hinge to size with a hacksaw. The hinge is UL Listed for use with labeled fire doors.

For technical drawings and 3-D models, click on a part number.

In addition to rotating 360°, these hinges tilt up and down. Constant resistance through the full range of motion holds lids, panels, and doors at any angle.

For technical drawings and 3-D models, click on a part number.