Metal hose fittings have better durability than plastic barbed hose fittings.

Eliminate sharp bends at the end of your air and water hose—these fittings have a built-in kink absorber.

Also known as ball-seat hose nipples, these fittings consist of a barbed shaft with a rounded end that sits inside a female threaded nut. When mated with a male threaded fitting, the rounded end presses tightly against the inside of the male threads for a better seal than a single-piece fitting. Once assembled, insert the barbed end into hose and secure with a clamp or a crimp-on hose ferrule.

Use these fittings with power washer guns and in other high-pressure water supply applications.

Fittings are threaded on both ends so you can connect them directly to a threaded hose or to pumps, cylinders, and other equipment in your hydraulic system.

Fittings have sharp barbs that grip push-on hose with no clamps or ferrules required. The more you pull on the fittings, the tighter the hose will grip. Use in low-pressure hydraulic applications up to 350 psi.

Create or repair D.O.T. hose assemblies in the field with just a wrench and a vise, no crimper required.

Attach these fittings to garden hose for a variety of water supply applications. They are metal for better durability than plastic garden hose fittings.

Built with ball bearings, these fittings continuously swivel 360° before and after installation to prevent your hose from twisting, kinking, and failing. They’re made of 316 stainless steel, so they won’t corrode from a wide variety of chemicals, as well as fuels, gasoline, and oil.

The pin lugs on these fittings allow for easy gripping, so you can quickly connect to fire hydrants and washdown equipment.

Use these two-piece fittings in grease and lubrication lines. They screw directly onto hose without the need for a separate adapter. When assembled, the fitting compresses against the hose, forming a strong seal. Also known as reusable fittings, they can be unscrewed from the hose end and used on a new hose.

Designed for coolant applications up to 200 psi, these fittings have a standard barbed end that slides into hose and secures with a clamp.

Slide the barbed end of these swivels into your dispensing hose and connect with a clamp. They rotate before and after installation as needed to prevent hose from twisting, kinking, and wearing prematurely.