To stop leaks in metal tanks and equipment without draining the contents, heat the area with a heat gun or torch to melt the stick and form a permanent seal. The resulting patch can withstand pressure up to 600 psi. These sticks meet NSF/ANSI 61 safety standards for use with drinking water systems.

To stop leaks in metal tanks and equipment without draining the contents, rub the smaller stick into the leak until it stops. Then, cut the desired amount from the larger stick, knead to a uniform color to mix, and press into place. The size listed is the combined total of the two parts.

These surface fillers can be used on vertical surfaces without sagging. They repair cracked, worn, and damaged surfaces. The size listed is the combined total of the two parts.

Stop leaks in metal tanks and equipment without draining the contents. Until a permanent repair can be made, rub these sticks into the leak to form a temporary seal.

Repair holes in LDPE tanks and containers with these patches. As you spin these patches with a handheld electric router, they melt into the surface of your tank for a seal without any joints. To hold these patches in your router, you’ll need the installation tool (sold separately).

For proper installation, you’ll want to use a hole saw to drill a hole that matches the For Hole Diameter listed and check that your router meets the speed and power requirements shown in the table.